Vehicle
Wiring Details for your
2010-2011 Lexus Gx460 Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2010-2011 Lexus Gx460 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
BLACK (+) |
@ DASH USE BOX, (WHITE, 1-PIN PLUG(K), PIN 1 |
STARTER |
LT. GREEN (-) and RED (-) |
@ ENGINE SWITCH, ( BLACK, 14-PIN PLUG), PIN 7 and 2 |
STARTER
2 |
BLACK (+) |
WHITE 30-PIN PLUG, PIN 3 @ PMC-ECU, See NOTE #7 |
IGNITION
1 |
BLUE (+) |
in DRIVERS KIK PANEL, (WHITE, 64-PIN PLUG), PIN 3 |
IGNITION
2 |
PURPLE (+) |
@ DASH FUSE BOX, (REAR, WHITE, 56-PIN PLUG(A), PIN 52 |
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
RED (+) |
@ DASH FUSE BOX, (REAR, WHITE, 56-PIN PLUG(A), PIN 48 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
WHITE (-) |
@BECU, (WHITE, 30-PIN PLUG), PIN 30, NOTE #5 |
PARKING
LIGHTS ( + ) |
LT. GREEN (+) |
@ DASH FUSE BOX, (WHITE, 36-PIN PLUG(H), PIN 16 |
POWER LOCK |
GRAY (TYPE B), (TEST with PASSENGER Switch) NOTE #2 |
@BECU, (WHITE, 30-PIN PLUG), PIN 9, NOTE #5 |
POWER UNLOCK |
LT. GREEN (TYPE B), (TEST with PASSENGER Switch) NOTE #3 |
@BECU, (WHITE, 30-PIN PLUG), PIN 10, NOTE #5 |
DOOR TRIGGER |
RED (-) |
@ DASH FUSE BOX, (WHITE, 36-PIN PLUG(H), PIN 27 |
DOMELIGHT
SUPERVISION |
GREEN (-) |
@ DASH FUSE BOX, (REAR, WHITE, 40-PIN PLUG(D), PIN 18 |
TRUNK RELEASE |
LT. GREEN (-) (Hatch Glass) NOTE #6 |
@ DASH FUSE BOX, (WHITE, 28-PIN PLUG), PIN 17 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
GREEN (-) |
@ DASH FUSE BOX, (WHITE, 40-PIN PLUG(F), PIN 29 |
TACH |
PINK (AC) |
@ DATA LINK Connector, (WHIT, 16-PIN PLUG) PIN 9, Under Drivers Dash |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
PURPLE (+) |
in DRIVERS KICK PANEL, (WHITE, 38-PIN PLUG), PIN 39 |
FACTORY
ALARM DISARM |
LT. GREEN (-) Requires Double Pulse, NOTE #4 |
@BECU, (WHITE, 30-PIN PLUG), PIN 24, NOTE #5 |
ANTI-THEFT |
TOYOTA'S TRANPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
|
EXTRA
INFORMATION |
NOTE #1; Vehicle is equipped with TOYOTA'S TANSPONDER ANTI-THEFT SYSTEM require
BYPASS MODULE 791 (REMOTE STARTING ONLY) and an extra ignition key for
operation.
part # PK-ALL (REMOTE STARTING ONLY) DOES NOT require an extra ignition key for
operation.
part # DB-ALL (REMOTE STARTING/KEYLESS ENTRY) DOES NOT require an extra
ignition key for operation.
NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Arm wire.
NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Disarm wire.
NOTE #4: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock
the Doors.
NOTE #5: the BECU,(Body Electronic Control Unit) is located under the Drivers Side Dash,
and is attached to the RIGHT side of the DASH FUSE BOX.
NOTE #6: TEST this wire while opening the Hatch Glass with the Handle on the Rear of
the vehicle.
NOTE #7; the POWER MANAGEMENT CONTROL ECU is located behind the GLOVEBOX.
|
|
|
|
|