Lexus Gx460 2010-2011 Printer Friendly Wiring Chart

Lexus Gx460 2010-2011

PART	COLOR	LOCATION
12 VOLT CONSTANT	BLACK (+)	@ DASH USE BOX, (WHITE, 1-PIN PLUG(K), PIN 1
STARTER	LT. GREEN (-) and RED (-)	@ ENGINE SWITCH, ( BLACK, 14-PIN PLUG), PIN 7 and 2
STARTER 2	BLACK (+)	WHITE 30-PIN PLUG, PIN 3 @ PMC-ECU, See NOTE #7
IGNITION 1	BLUE (+)	in DRIVERS KIK PANEL, (WHITE, 64-PIN PLUG), PIN 3
IGNITION 2	PURPLE (+)	@ DASH FUSE BOX, (REAR, WHITE, 56-PIN PLUG(A), PIN 52
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	RED (+)	@ DASH FUSE BOX, (REAR, WHITE, 56-PIN PLUG(A), PIN 48
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE (-)	@BECU, (WHITE, 30-PIN PLUG), PIN 30, NOTE #5
PARKING LIGHTS ( + )	LT. GREEN (+)	@ DASH FUSE BOX, (WHITE, 36-PIN PLUG(H), PIN 16
POWER LOCK	GRAY (TYPE B), (TEST with PASSENGER Switch) NOTE #2	@BECU, (WHITE, 30-PIN PLUG), PIN 9, NOTE #5
POWER UNLOCK	LT. GREEN (TYPE B), (TEST with PASSENGER Switch) NOTE #3	@BECU, (WHITE, 30-PIN PLUG), PIN 10, NOTE #5
DOOR TRIGGER	RED (-)	@ DASH FUSE BOX, (WHITE, 36-PIN PLUG(H), PIN 27
DOMELIGHT SUPERVISION	GREEN (-)	@ DASH FUSE BOX, (REAR, WHITE, 40-PIN PLUG(D), PIN 18
TRUNK RELEASE	LT. GREEN (-) (Hatch Glass) NOTE #6	@ DASH FUSE BOX, (WHITE, 28-PIN PLUG), PIN 17
SLIDING POWER DOOR	N/A
HORN	GREEN (-)	@ DASH FUSE BOX, (WHITE, 40-PIN PLUG(F), PIN 29
TACH	PINK (AC)	@ DATA LINK Connector, (WHIT, 16-PIN PLUG) PIN 9, Under Drivers Dash
WAIT TO START LIGHT	N/A
BRAKE	PURPLE (+)	in DRIVERS KICK PANEL, (WHITE, 38-PIN PLUG), PIN 39
FACTORY ALARM DISARM	LT. GREEN (-) Requires Double Pulse, NOTE #4	@BECU, (WHITE, 30-PIN PLUG), PIN 24, NOTE #5
ANTI-THEFT	TOYOTA'S TRANPONDER ANTI-THEFT SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1; Vehicle is equipped with TOYOTA'S TANSPONDER ANTI-THEFT SYSTEM require BYPASS MODULE 791 (REMOTE STARTING ONLY) and an extra ignition key for operation. part # PK-ALL (REMOTE STARTING ONLY) DOES NOT require an extra ignition key for operation. part # DB-ALL (REMOTE STARTING/KEYLESS ENTRY) DOES NOT require an extra ignition key for operation. NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Arm wire. NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Disarm wire. NOTE #4: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock the Doors. NOTE #5: the BECU,(Body Electronic Control Unit) is located under the Drivers Side Dash, and is attached to the RIGHT side of the DASH FUSE BOX. NOTE #6: TEST this wire while opening the Hatch Glass with the Handle on the Rear of the vehicle. NOTE #7; the POWER MANAGEMENT CONTROL ECU is located behind the GLOVEBOX.