2009-2011 Lincoln Mks Vehicle Wiring Chart and Diagram

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) 80AMP, Note #2	@ SJB, (1-Pin Plug(G), Pin 1, Note #7
STARTER	BLUE/WHITE (+) Note #3	@ IGNITION SWITCH, (7-Pin Plug) Pin 7
STARTER 2	BROWN/PURPLE(-) (S/S1), YELLOW/ORANGE(-) (S/S2) (INTELLIGENT ACCESS) Note #4	@ START/STOP Switch or RFA, (Connector D) Pin 16 and (Connector E) Pin 4
IGNITION 1	WHITE/ORANGE (+), Note #5	@ IGNITION SWITCH, (7-Pin Plug) Pin 1
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE/GREEN (+) Note #6	@ IGNITION SWITCH, (7-Pin Plug) Pin 6
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	PURPLE/WHITE (+)	in DRIVERS KICK Panel or SJB, (32-Pin Plug(D), Pin 20, Note #7
POWER LOCK	BLUE/GREEN (TYPE B), Note #8 and #9	in PASSENGER KICK Panel or SJB, (26-Pin Plug(C), Pin 17, Note #7
POWER UNLOCK	YELLOW, PURPLE (TYPE B), Note #8 and #10	in PASSENGER KICK Panel or SJB, (26-Pin Plug(C), Pin 4, Note #7
DOOR TRIGGER	GREEN/PURPLE (-) N.C. Note #12	in DRIVERS KICK Panel or SJB, (26-Pin Plug(C), Pin 14, Note #7
DOMELIGHT SUPERVISION	GRAY/PURPLE (+)	in DRIVERS KICK Panel or SJB, (14-Pin Plug(A), Pin 9, Note #7
TRUNK RELEASE	BROWN/YELLOW (-) Note #13	in DRIVERS KICK Panel or SJB, (26-Pin Plug(C), Pin 20, Note #7
SLIDING POWER DOOR	N/A
HORN	BLUE/WHITE (-)	@ HORN Switch or SJB, 52-Pin Plug(B) Pin 41, Note #7
TACH	Any wire NOT BLUE (AC)	@ Any FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	PURPLE/WHITE (+)	@ BRAKE Switch in Drivers Kick PanSJB, 52-Pin Plug(B) Pin 40, Note #7el or
FACTORY ALARM DISARM	GREEN/PURPLE (-) Note #14	@ DRIVERS DOOR MODULE, in Door, (12-Pin Plug) Pin 12
ANTI-THEFT	FORD's TRANSPONDER SYSTEM, Requires Bypass Module, See Note #1

EXTRA INFORMATION

NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKFM, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. Note #2: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector C) PIN 1. Note #3: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector B) PIN 2. Note #4: On vehicles with INTELLIGENT ACCESS, these wires are located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector D) PIN 16 and (Connector E), PIN 4. Note #5: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector B) PIN 5. Note #6: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector B) PIN 4. Note #7: The SJB, (Smart Junction Box) is part of the FUXE BOX, located under the Drivers Dash. Note #8: TEST this wire while pressing the PASSENGER Door Lock Switch Note #9: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 16. Note #10: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 17. Note #11: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector D) PIN 2. Note #12: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 19. Note #13: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 15. Note #14: TEST this wire while turning the Key in the Drivers Door.