Lincoln  Mks 2009-2011
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+) 80AMP, Note #2   @ SJB, (1-Pin Plug(G), Pin 1, Note #7
 STARTER  BLUE/WHITE (+) Note #3  @ IGNITION SWITCH, (7-Pin Plug) Pin 7
 STARTER 2  BROWN/PURPLE(-) (S/S1), YELLOW/ORANGE(-) (S/S2) (INTELLIGENT ACCESS) Note #4  @ START/STOP Switch or RFA, (Connector D) Pin 16 and (Connector E) Pin 4
 IGNITION 1  WHITE/ORANGE (+), Note #5  @ IGNITION SWITCH, (7-Pin Plug) Pin 1
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  PURPLE/GREEN (+) Note #6  @ IGNITION SWITCH, (7-Pin Plug) Pin 6
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  PURPLE/WHITE (+)  in DRIVERS KICK Panel or SJB, (32-Pin Plug(D), Pin 20, Note #7
 POWER LOCK  BLUE/GREEN (TYPE B), Note #8 and #9  in PASSENGER KICK Panel or SJB, (26-Pin Plug(C), Pin 17, Note #7
 POWER UNLOCK  YELLOW, PURPLE (TYPE B), Note #8 and #10  in PASSENGER KICK Panel or SJB, (26-Pin Plug(C), Pin 4, Note #7
 DOOR TRIGGER  GREEN/PURPLE (-) N.C. Note #12  in DRIVERS KICK Panel or SJB, (26-Pin Plug(C), Pin 14, Note #7
 DOMELIGHT SUPERVISION  GRAY/PURPLE (+)  in DRIVERS KICK Panel or SJB, (14-Pin Plug(A), Pin 9, Note #7
 TRUNK RELEASE  BROWN/YELLOW (-) Note #13  in DRIVERS KICK Panel or SJB, (26-Pin Plug(C), Pin 20, Note #7
 SLIDING POWER DOOR  N/A  
 HORN  BLUE/WHITE (-)  @ HORN Switch or SJB, 52-Pin Plug(B) Pin 41, Note #7
 TACH  Any wire NOT BLUE (AC)  @ Any FUEL INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  PURPLE/WHITE (+)  @ BRAKE Switch in Drivers Kick PanSJB, 52-Pin Plug(B) Pin 40, Note #7el or
 FACTORY ALARM DISARM   GREEN/PURPLE (-) Note #14  @ DRIVERS DOOR MODULE, in Door, (12-Pin Plug) Pin 12
 ANTI-THEFT  FORD's TRANSPONDER SYSTEM, Requires Bypass Module, See Note #1  
 EXTRA INFORMATION
 NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKFM, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. Note #2: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector C) PIN 1. Note #3: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector B) PIN 2. Note #4: On vehicles with INTELLIGENT ACCESS, these wires are located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector D) PIN 16 and (Connector E), PIN 4. Note #5: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector B) PIN 5. Note #6: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector B) PIN 4. Note #7: The SJB, (Smart Junction Box) is part of the FUXE BOX, located under the Drivers Dash. Note #8: TEST this wire while pressing the PASSENGER Door Lock Switch Note #9: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 16. Note #10: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 17. Note #11: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector D) PIN 2. Note #12: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 19. Note #13: On vehicles with INTELLIGENT ACCESS, this wire is located at the REMOTE FUNCTION ACTUATOR Module, behind the Glove Box (Connector E) PIN 15. Note #14: TEST this wire while turning the Key in the Drivers Door.