Vehicle
Wiring Details for your
2009-2010 Lincoln Mkx Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2010 Lincoln Mkx . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+) 100AMP |
@ SJB, (BLACK, 1-Pin Plug(G), Pin 1,Note #2 |
STARTER |
BLUE/WHITE (+) |
@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 7 |
STARTER
2 |
N/A |
|
IGNITION
1 |
WHITE/ORANGE (+) |
@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 1 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
PURPLE/GREEN (+) |
@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 6 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
N/A |
KEYSENSE |
BLUE/GRAY (+) |
@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 5 |
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
PURPLE/WHITE (+) |
in DRIVERS KICK PANEL or @ SJB, (BLACK, 32-Pin Plug(D), Pin 20,Note #2 |
POWER LOCK |
GRAY/YELLOW (TYPE B) |
in DRIVERS KICK PANEL or @ SJB, (GRAY, 26-Pin Plug(C), Pin 17,Note #2 |
POWER UNLOCK |
PURPLE/GRAY (TYPE B) |
in DRIVERS KICK PANEL or @ SJB, (GRAY 26-Pin Plug(C), Pin 4,Note #2 |
DOOR TRIGGER |
GREEN/PURPLE (-) N.C. |
in DRIVERS KICK PANEL or @ SJB, (GRAY, 26-Pin Plug(C), Pin 14, Note #2 |
DOMELIGHT
SUPERVISION |
GRAY/PURPLE (+) |
in DRIVERS KICK PANEL or @ SJB, (GRAY, 14-Pin Plug(A), Pin 9, Note #2 |
TRUNK RELEASE |
BROWN (-), Note #3 |
in DRIVERS KICK PANEL or @ SJB, (GRAY, 26-Pin Plug(C), Pin 7, Note #2 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
BLUE/WHITE (-) |
@ HORN Switch or SJB, (BLACK 52-Pin Plug(B), Pin 41, Note #2 |
TACH |
Any wire NOT BLUE (AC) |
@ ANY FUEL INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
PURPLE/WHITE (+) |
@ BRAKE Switch or SJB, (BLACK, 52-Pin Plug(b), Pin 40, Note #2 |
FACTORY
ALARM DISARM |
PURPLE/BROWN (-) Note #4 |
in DRIVERS KICK PANEL or SJB, (GRAY 26-Pin Plug(C), Pin 8, Note #2 |
ANTI-THEFT |
TRANSPONDER ANTI-THEFT REQUIRES BYPASS MODULE, See Note #1 |
IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791, use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKFM or PK-ALL, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website.
Note #2: The SJB, (Smart Junction Box) is located under the Drivers Dash.
Note #3: TEST this wire while opening the Liftgate from the Handle on the Rear of the Vehicle.
On vehiles with Power Liftgate, the Open/Close wire is a GRAY/YELLOW (-) @ the
Power Liftgate Switch on the Dash or in the Drivers Kick Panel, harness to rear of
vehicle.
Note #4: TEST this wire while turning the Key in the Drivers Door.
|
|
|
|
|