Lincoln Mkx 2009-2010 Printer Friendly Wiring Chart

Lincoln Mkx 2009-2010

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) 100AMP	@ SJB, (BLACK, 1-Pin Plug(G), Pin 1,Note #2
STARTER	BLUE/WHITE (+)	@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 7
STARTER 2	N/A
IGNITION 1	WHITE/ORANGE (+)	@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 1
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PURPLE/GREEN (+)	@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 6
ACCESSORY/HEATER BLOWER 2	N/A	N/A
KEYSENSE	BLUE/GRAY (+)	@ IGNITION Harness, (BLACK 7-Pin Plug) Pin 5
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	PURPLE/WHITE (+)	in DRIVERS KICK PANEL or @ SJB, (BLACK, 32-Pin Plug(D), Pin 20,Note #2
POWER LOCK	GRAY/YELLOW (TYPE B)	in DRIVERS KICK PANEL or @ SJB, (GRAY, 26-Pin Plug(C), Pin 17,Note #2
POWER UNLOCK	PURPLE/GRAY (TYPE B)	in DRIVERS KICK PANEL or @ SJB, (GRAY 26-Pin Plug(C), Pin 4,Note #2
DOOR TRIGGER	GREEN/PURPLE (-) N.C.	in DRIVERS KICK PANEL or @ SJB, (GRAY, 26-Pin Plug(C), Pin 14, Note #2
DOMELIGHT SUPERVISION	GRAY/PURPLE (+)	in DRIVERS KICK PANEL or @ SJB, (GRAY, 14-Pin Plug(A), Pin 9, Note #2
TRUNK RELEASE	BROWN (-), Note #3	in DRIVERS KICK PANEL or @ SJB, (GRAY, 26-Pin Plug(C), Pin 7, Note #2
SLIDING POWER DOOR	N/A
HORN	BLUE/WHITE (-)	@ HORN Switch or SJB, (BLACK 52-Pin Plug(B), Pin 41, Note #2
TACH	Any wire NOT BLUE (AC)	@ ANY FUEL INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	PURPLE/WHITE (+)	@ BRAKE Switch or SJB, (BLACK, 52-Pin Plug(b), Pin 40, Note #2
FACTORY ALARM DISARM	PURPLE/BROWN (-) Note #4	in DRIVERS KICK PANEL or SJB, (GRAY 26-Pin Plug(C), Pin 8, Note #2
ANTI-THEFT	TRANSPONDER ANTI-THEFT REQUIRES BYPASS MODULE, See Note #1	IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKFM or PK-ALL, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. Note #2: The SJB, (Smart Junction Box) is located under the Drivers Dash. Note #3: TEST this wire while opening the Liftgate from the Handle on the Rear of the Vehicle. On vehiles with Power Liftgate, the Open/Close wire is a GRAY/YELLOW (-) @ the Power Liftgate Switch on the Dash or in the Drivers Kick Panel, harness to rear of vehicle. Note #4: TEST this wire while turning the Key in the Drivers Door.