Vehicle
Wiring Details for your
2009-2010 Kia Borrego Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2010 Kia Borrego . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
WHITE (+), NOTE #2 |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 5 |
STARTER |
ORANGE (+), NOTE #3 |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 1 |
STARTER
2 |
BLACK/ORANGE (+) and PINK (+), (PUSH-BUTTON START) |
@ START/STOP BUTTON SWITCH, (10-PIN PLUG), PINS 1 and 7 |
IGNITION
1 |
GREEN (+), NOTE #4 |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 6 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BLUE (+), NOTE #5 |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 3 |
ACCESSORY/HEATER
BLOWER 2 |
PINK (+), NOTE #6 |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 4 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BLUE (-) |
@ HEADLIGHT SWITCH or DASH FUSE BOX, (BLUE, 72-PIN PLUG), PIN 69 |
PARKING
LIGHTS ( + ) |
N/A |
|
POWER LOCK |
NOTE #7 |
@ DDM, (23-PIN PLUG), PINS 15 and 17, NOTE #11 |
POWER UNLOCK |
NOTE #8 |
@ DDM, (23-PIN PLUG), PINS 5 and 17, NOTE #11 |
DOOR TRIGGER |
YELLOW (-) |
@ RAM, (RIGHT, 42-PIN PLUG), PIN 7, NOTE #12 |
DOMELIGHT
SUPERVISION |
ORANGE/BLACK(-)(Front) and BLUE(-)(Center and Rear) |
in DRIVERS KICK PANEL or RAM, (RIGHT, 42-PIN PLUG), PINS 20 and 21, NOTE #12 |
TRUNK RELEASE |
RED/ORANGE (-), NOTE #9 |
@ RAM, (TOP LEFT, 16-PIN PLUG), PIN 4, NOTE #12 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
GRAY (-) |
@ HORN SWITCH or DASH FUSE BOX, (BLUE, 72-PIN PLUG), PIN 44 |
TACH |
NOTE #10 |
@ Any FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
WHITE (+) |
@ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, HARNESS to REAR of Vehicle |
FACTORY
ALARM DISARM |
Use UNLOCK wires |
|
ANTI-THEFT |
KIA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: on Vehicles with SMART KEY, this wire is located in the FRONT DRIVERS SIDE of the
CENTER CONSOLE, (10-PIN PLUG), PIN 1
NOTE #3: on Vehicles with SMART KEY, this wire is a RED (+), located at the DASH FUSE BOX,
(REAR BLACK, 56-PIN PLUG), PIN 21
NOTE #4: on Vehicles with SMART KEY, this wire is located at the DASH FUSE BOX,
(REAR BLACK, 56-PIN PLUG), PIN 55
NOTE #5: on Vehicles with SMART KEY, this wire is located at the DASH FUSE BOX,
(REAR BLACK, 56-PIN PLUG), PIN 16
NOTE #6: on Vehicles with SMART KEY, this wire is located at the DASH FUSE BOX,
(REAR BLACK, 56-PIN PLUG), PIN 7
NOTE #7: to LOCK/ARM, use the ORANGE (TYPE B), and the YELLOW (Open) use both wires,
TEST these wires while turning the KEY in the Drivers Door.
NOTE #8: to UNLOCK/DISARM, use the RED (TYPE B), and the YELLOW (TYPE B) use both wires,
will Require a Double Pulse. TEST these wires while turning the KEY in the Drivers Door.
NOTE #9: TEST this wire while Opening the TAILGATE with the Handle on the REAR of the Vehicle.
NOTE #10: When using the TACH wire, use Any wire NOT ORANGE (V6 Engine) and Any wire NOT
WHITE/BLACK (V8 Engine) both test (AC)
NOTE #11: the DDM, (Drivers Door Module) is located in the Drivers Door.
NOTE #12: the RAM, (Rear Area Module) is the FUSE BOX located in the LEFT REAR QUARTER
PANEL.
|
|
|
|
|