Vehicle
Wiring Details for your
2008-2011 Lexus Ls600h Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2011 Lexus Ls600h . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
BLACK (+) |
@ DRIVERS DASH FUSE BOX, (WHITE, 1-PIN PLUG(F) PIN 1 |
STARTER |
WHITE (-) and BLUE (-) |
@ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PINS 7 and 2 |
STARTER
2 |
BLACK (+) |
@ BECU, (WHITE, 10-PIN PLUG) PIN 4, NOTE #3 |
IGNITION
1 |
PINK (+) |
@ BECU, (WHITE, 28-PIN PLUG) PIN 11, NOTE #3 |
IGNITION
2 |
PURPLE(+) |
@ BECU, (WHITE, 26-PIN PLUG) PIN 3, NOTE #3 |
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
GREEN (+) |
@ BECU, (WHITE, 26-PIN PLUG) PIN 22, NOTE #3 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BLUE (-) |
@ HEADLIGHT SWITCH, (WHITE, 20-PIN PLUG) PIN 18 |
PARKING
LIGHTS ( + ) |
N/A |
|
POWER LOCK |
BLACK (TYPE B), (TEST with PASSENGER Switch) NOTE #4 |
@ FRONT (RH), DOOR CONTROL ECU, (WHITE, 30-PIN PLUG) PIN 11, in PASSENGER DOOR |
POWER UNLOCK |
RED (TYPE B), (TEST with PASSENGER Switch) NOTE #5 |
@ FRONT (RH), DOOR CONTROL ECU, (WHITE, 30-PIN PLUG) PIN 12, in PASSENGER DOOR |
DOOR TRIGGER |
WHITE (-) |
@ BECU, (WHITE, 26-PIN PLUG) PIN 24, NOTE #3 |
DOMELIGHT
SUPERVISION |
Use DOOR TRIGGER |
|
TRUNK RELEASE |
BLUE (-) |
@ BECU, (WHITE, 26-PIN PLUG) PIN 26, NOTE #3 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
GREEN or BLACK (-) (Low) and GREEN or BLACK (-) (High) |
@ HORNS or FRONT CONTROLLER, (WHITE, 24-PIN PLUG) PINS 1 and 2, NOTE #6 |
TACH |
BLACK (AC) |
@ DATA LINK Connector, (WHITE, 16-PIN PLUG) PIN 9, under Drivers Dash |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
BLUE (+) |
@ DRIVERS DASH FUSE BOX, (GRAY, 24-PIN PLUG) PIN 15 |
FACTORY
ALARM DISARM |
GRAY (-) Requires Double Pulse, NOTE #2 |
@ FRONT (LH), DOOR CONTROL ECU, (WHITE, 26-PIN PLUG) PIN 22, in DRIVERS DOOR |
ANTI-THEFT |
TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1 |
|
EXTRA
INFORMATION |
NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is
required to be placed inside this module for Operation.
Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS
NO KEY is required for Operation.
Part # DB-ALL Bypass Module, this Module is a KEYLESS BYPASS MODULE and DOES
NOT require a Key to be placed inside the Module for Operation, this module will also
do the Keyless Entry.
To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this
website
NOTE #2: TEST this wire while turning the Key in the Drivers Door.
NOTE #3: the BECU, (Body Electronic Control Unit) is located under the DRIVERS Dash and
attached to the Right side of the Drivers Dash FUSE BOX.
NOTE #4: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Arm wire.
NOTE #5: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Disarm wire.
NOTE #6: the FRONT CONTROLLER is located under the RIGHT FRONT Corner of the ENGINE
COMPARTMENT, next to the ENGINE COMPARTMENT FUSE BOX.
|
|
|
|
|