Lexus  Ls600h 2008-2011
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   BLACK (+)   @ DRIVERS DASH FUSE BOX, (WHITE, 1-PIN PLUG(F) PIN 1
 STARTER  WHITE (-) and BLUE (-)  @ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PINS 7 and 2
 STARTER 2  BLACK (+)  @ BECU, (WHITE, 10-PIN PLUG) PIN 4, NOTE #3
 IGNITION 1  PINK (+)  @ BECU, (WHITE, 28-PIN PLUG) PIN 11, NOTE #3
 IGNITION 2  PURPLE(+)  @ BECU, (WHITE, 26-PIN PLUG) PIN 3, NOTE #3
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  GREEN (+)  @ BECU, (WHITE, 26-PIN PLUG) PIN 22, NOTE #3
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  BLUE (-)  @ HEADLIGHT SWITCH, (WHITE, 20-PIN PLUG) PIN 18
 PARKING LIGHTS ( + )  N/A  
 POWER LOCK  BLACK (TYPE B), (TEST with PASSENGER Switch) NOTE #4  @ FRONT (RH), DOOR CONTROL ECU, (WHITE, 30-PIN PLUG) PIN 11, in PASSENGER DOOR
 POWER UNLOCK  RED (TYPE B), (TEST with PASSENGER Switch) NOTE #5  @ FRONT (RH), DOOR CONTROL ECU, (WHITE, 30-PIN PLUG) PIN 12, in PASSENGER DOOR
 DOOR TRIGGER  WHITE (-)  @ BECU, (WHITE, 26-PIN PLUG) PIN 24, NOTE #3
 DOMELIGHT SUPERVISION  Use DOOR TRIGGER  
 TRUNK RELEASE  BLUE (-)  @ BECU, (WHITE, 26-PIN PLUG) PIN 26, NOTE #3
 SLIDING POWER DOOR  N/A  
 HORN  GREEN or BLACK (-) (Low) and GREEN or BLACK (-) (High)  @ HORNS or FRONT CONTROLLER, (WHITE, 24-PIN PLUG) PINS 1 and 2, NOTE #6
 TACH  BLACK (AC)  @ DATA LINK Connector, (WHITE, 16-PIN PLUG) PIN 9, under Drivers Dash
 WAIT TO START LIGHT  N/A  
 BRAKE  BLUE (+)  @ DRIVERS DASH FUSE BOX, (GRAY, 24-PIN PLUG) PIN 15
 FACTORY ALARM DISARM   GRAY (-) Requires Double Pulse, NOTE #2  @ FRONT (LH), DOOR CONTROL ECU, (WHITE, 26-PIN PLUG) PIN 22, in DRIVERS DOOR
 ANTI-THEFT  TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1  
 EXTRA INFORMATION
 NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is required to be placed inside this module for Operation. Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS NO KEY is required for Operation. Part # DB-ALL Bypass Module, this Module is a KEYLESS BYPASS MODULE and DOES NOT require a Key to be placed inside the Module for Operation, this module will also do the Keyless Entry. To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: TEST this wire while turning the Key in the Drivers Door. NOTE #3: the BECU, (Body Electronic Control Unit) is located under the DRIVERS Dash and attached to the Right side of the Drivers Dash FUSE BOX. NOTE #4: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Arm wire. NOTE #5: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Disarm wire. NOTE #6: the FRONT CONTROLLER is located under the RIGHT FRONT Corner of the ENGINE COMPARTMENT, next to the ENGINE COMPARTMENT FUSE BOX.