Vehicle
Wiring Details for your
2008-2009 Land Rover Range Rover Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2009 Land Rover Range Rover . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+), 30 AMP |
@ IGNITION SWITCH, (PIN 6) |
STARTER |
BLACK/YELLOW (+) |
@ IGNITION SWITCH, (PIN 8) |
STARTER
2 |
N/A |
|
IGNITION
1 |
GREEN (+) |
@ IGNITION SWITCH, (PIN 9) |
IGNITION
2 |
PURPLE/BLACK (+) |
@ IGNITION SWITCH, (PIN 2) |
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BLACK, NOTE #3 |
@ HEADLIGHT SWITCH or LIGHTING SWITCH MODULE, (BLACK, 54-PIN PLUG), PIN 51, NOTE #5 |
PARKING
LIGHTS ( + ) |
GRAY/GREEN(+)(Left) and GRAY/BLUE(+)(Right), NOTE #4 |
@ LIGHTING SWITCH MODULE, (BLACK, 54-PIN PLUG), PIN 18 and (BLACK, 15-PIN PLUG), PIN 3, NOTE #5 |
POWER LOCK |
YELLOW/RED (-), NOTE #6 |
@ GEM, (WHITE, 26-PIN PLUG), PIN 24, NOTE #7 |
POWER UNLOCK |
Use LOCK wire |
|
DOOR TRIGGER |
BROWN/WHITE (-) |
@ DRIVERS DOOR MODULE, (BLACK, 12-PIN PLUG), PIN 11 |
DOMELIGHT
SUPERVISION |
RED/BLUE (-) |
@ GEM, (BLACK, 20-PIN PLUG), PIN 20, NOTE #7 |
TRUNK RELEASE |
GRAY/BROWN(-)(Upper Tailgate) and RED/GRAY(-)(Lower Tailgate) |
@ GEM, (BLACK, 26-PIN PLUG), PIN 11, NOTE #7 and REAR JUNCTION BOX, (WHITE, 10-PIN PLUG), PIN 3, NOTE #8 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
BROWN/RED (-) |
@ HORN SWITCH |
TACH |
NOTE #9 |
@ Any FUEL-INJECTOR |
WAIT TO
START LIGHT |
BLUE/RED (-) |
@ ECM, (Connector(A), PIN H2 |
BRAKE |
PURPLE/GREEN (+) (TEST with IGNITION ON) |
@ BRAKE PEDAL SWITCH, (4-PIN PLUG), PIN 3 |
FACTORY
ALARM DISARM |
WHITE/BLCK (-) Requiresdouble Pulse, NOTE #10 |
@ DRIVERS DOOR MODULE, (BLACK, 12-PIN PLUG), PIN 3 |
ANTI-THEFT |
LAND ROVER'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: the BCU (Body Control Unit) is located under the PASSENGER SEAT.
NOTE #2: a (-)Negative or TYPE B pluse on this wire will alternate between LOCK and UNLOCK, See DIAGRAM
NOTE #3: INTERRUPT or BREAKING this wire will TURN ON the PARKING LIGHTS use a RELAY.
NOTE #4: the LEFT REAR Parking light is a GRAY/PURPLE(+) and the RIGHT REAR Parking light is a GRAY/WHITE(+) at the LIGHTING SWITCH MODULE, (BLACK, 15-PIN PLUG), PIN 2 and (BLACK, 54-PIN PLUG), PIN 17
NOTE #5: the LIGHTING SWITCH MODULE, is located in the DRIVERS KICK PANEL
NOTE #6: a (-)Negative or TYPE B pluse on this wire will alternate between LOCK and UNLOCK
NOTE #7: the GEM, (Generic Electronic Module) is located under the FRONT PASSENGER SEAT
NOTE #8; the REAR JUNCTION BOX is in the RIGHT side of the LUGGAGE Compartment.
NOTE #9: on GAS Engines the TACH is any wire NOT BROWN/RED and on DIESEL it is any wire NOT with a GREEN STRIPE, both test (AC)
NOTE #10: TEST this wire while turning the Key in the Drivers Door.
|
|
|
|
|