Land Rover Range Rover 2008-2009 Printer Friendly Wiring Chart

Land Rover Range Rover 2008-2009

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+), 30 AMP	@ IGNITION SWITCH, (PIN 6)
STARTER	BLACK/YELLOW (+)	@ IGNITION SWITCH, (PIN 8)
STARTER 2	N/A
IGNITION 1	GREEN (+)	@ IGNITION SWITCH, (PIN 9)
IGNITION 2	PURPLE/BLACK (+)	@ IGNITION SWITCH, (PIN 2)
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	N/A
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BLACK, NOTE #3	@ HEADLIGHT SWITCH or LIGHTING SWITCH MODULE, (BLACK, 54-PIN PLUG), PIN 51, NOTE #5
PARKING LIGHTS ( + )	GRAY/GREEN(+)(Left) and GRAY/BLUE(+)(Right), NOTE #4	@ LIGHTING SWITCH MODULE, (BLACK, 54-PIN PLUG), PIN 18 and (BLACK, 15-PIN PLUG), PIN 3, NOTE #5
POWER LOCK	YELLOW/RED (-), NOTE #6	@ GEM, (WHITE, 26-PIN PLUG), PIN 24, NOTE #7
POWER UNLOCK	Use LOCK wire
DOOR TRIGGER	BROWN/WHITE (-)	@ DRIVERS DOOR MODULE, (BLACK, 12-PIN PLUG), PIN 11
DOMELIGHT SUPERVISION	RED/BLUE (-)	@ GEM, (BLACK, 20-PIN PLUG), PIN 20, NOTE #7
TRUNK RELEASE	GRAY/BROWN(-)(Upper Tailgate) and RED/GRAY(-)(Lower Tailgate)	@ GEM, (BLACK, 26-PIN PLUG), PIN 11, NOTE #7 and REAR JUNCTION BOX, (WHITE, 10-PIN PLUG), PIN 3, NOTE #8
SLIDING POWER DOOR	N/A
HORN	BROWN/RED (-)	@ HORN SWITCH
TACH	NOTE #9	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	BLUE/RED (-)	@ ECM, (Connector(A), PIN H2
BRAKE	PURPLE/GREEN (+) (TEST with IGNITION ON)	@ BRAKE PEDAL SWITCH, (4-PIN PLUG), PIN 3
FACTORY ALARM DISARM	WHITE/BLCK (-) Requiresdouble Pulse, NOTE #10	@ DRIVERS DOOR MODULE, (BLACK, 12-PIN PLUG), PIN 3
ANTI-THEFT	LAND ROVER'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1: the BCU (Body Control Unit) is located under the PASSENGER SEAT. NOTE #2: a (-)Negative or TYPE B pluse on this wire will alternate between LOCK and UNLOCK, See DIAGRAM NOTE #3: INTERRUPT or BREAKING this wire will TURN ON the PARKING LIGHTS use a RELAY. NOTE #4: the LEFT REAR Parking light is a GRAY/PURPLE(+) and the RIGHT REAR Parking light is a GRAY/WHITE(+) at the LIGHTING SWITCH MODULE, (BLACK, 15-PIN PLUG), PIN 2 and (BLACK, 54-PIN PLUG), PIN 17 NOTE #5: the LIGHTING SWITCH MODULE, is located in the DRIVERS KICK PANEL NOTE #6: a (-)Negative or TYPE B pluse on this wire will alternate between LOCK and UNLOCK NOTE #7: the GEM, (Generic Electronic Module) is located under the FRONT PASSENGER SEAT NOTE #8; the REAR JUNCTION BOX is in the RIGHT side of the LUGGAGE Compartment. NOTE #9: on GAS Engines the TACH is any wire NOT BROWN/RED and on DIESEL it is any wire NOT with a GREEN STRIPE, both test (AC) NOTE #10: TEST this wire while turning the Key in the Drivers Door.