Vehicle
Wiring Details for your
2007-2010 Kia Rondo Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2010 Kia Rondo . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
PINK (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 5 |
| STARTER |
GREEN (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 1 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLUE (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 6 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
PINK (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 3 |
| ACCESSORY/HEATER
BLOWER 2 |
BLUE (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 4 |
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
YELLOW (-) |
@ HEADLIGHT SWITCH or BCM, (26-PIN PLUG), PIN 10, NOTE #2 |
| PARKING
LIGHTS ( + ) |
GREEN/ORANGE(+)(Left) and GREEN/ORANGE(+)(Right) use both |
@ DASH FUSE BOX, (REAR BLUE, 14-PIN PLUG(G), PINS 1 and 8 |
| POWER LOCK |
WHITE (TYPE B) |
in DRIVERS KICK PANEL, (GRAY, 39-PIN PLUG), PIN 8 |
| POWER UNLOCK |
WHITE/BLACK (TYPE B), NOTE #3 |
in DRIVERS KICK PANEL, (GRAY, 39-PIN PLUG), PIN 9 |
| DOOR TRIGGER |
RED/BLACK (-) |
@ BCM, (26-PIN PLUG), PIN 4, NOTE #2 |
| DOMELIGHT
SUPERVISION |
Use LEFT FRONT, DOOR TRIGGER wire |
|
| TRUNK RELEASE |
BLUE/ORANGE (-) |
@ BCM, (22-PIN PLUG), PIN 18, NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
YELLOW/BLACK (-) |
in DRIVERS KICK PANEL, (BLUE, 42-PIN PLUG), PIN 25 |
| TACH |
WHITE, (AC) |
in DRIVERS KICK PANEL, (BLUE, 42-PIN PLUG), PIN 38 |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
GREEN (+) |
@ BRAKE PEDAL SWITCH, (4-PIN PLUG), PIN 1 |
| FACTORY
ALARM DISARM |
NOTE #4 |
in DRIVERS KICK PANEL, (GRAY, 39-PIN PLUG), PINS 2 and 1 |
| ANTI-THEFT |
KIA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the BCM, (Body Control Module) is located under the DRIVERS DASH, above the
BRAKE PEDAL.
NOTE #3; to UNLOCK just the DRIVERS DOOR, use the BLUE (-) at the BCM, (22-PIN PLUG),
PIN 16.
NOTE #4: to DISARM, use the BROWN (-), this is the DOOR KEY UNLOCK wire and the
YELLOW (-) this is the UNLOCK DETECTION wire, Requires Double Pulse, use both
and DIODE ISOLATE. TEST both of these wires while Turning the KEY in the Drivers
Door.
|
|
|
|
|
|
