Kia  Rondo 2007-2010
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   PINK (+)   @ IGNITION SWITCH, (6-PIN PLUG), PIN 5
 STARTER  GREEN (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN 1
 STARTER 2  N/A  
 IGNITION 1  BLUE (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN 6
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  PINK (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN 3
 ACCESSORY/HEATER BLOWER 2  BLUE (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN 4
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  YELLOW (-)  @ HEADLIGHT SWITCH or BCM, (26-PIN PLUG), PIN 10, NOTE #2
 PARKING LIGHTS ( + )  GREEN/ORANGE(+)(Left) and GREEN/ORANGE(+)(Right) use both  @ DASH FUSE BOX, (REAR BLUE, 14-PIN PLUG(G), PINS 1 and 8
 POWER LOCK  WHITE (TYPE B)  in DRIVERS KICK PANEL, (GRAY, 39-PIN PLUG), PIN 8
 POWER UNLOCK  WHITE/BLACK (TYPE B), NOTE #3  in DRIVERS KICK PANEL, (GRAY, 39-PIN PLUG), PIN 9
 DOOR TRIGGER  RED/BLACK (-)  @ BCM, (26-PIN PLUG), PIN 4, NOTE #2
 DOMELIGHT SUPERVISION  Use LEFT FRONT, DOOR TRIGGER wire  
 TRUNK RELEASE  BLUE/ORANGE (-)  @ BCM, (22-PIN PLUG), PIN 18, NOTE #2
 SLIDING POWER DOOR  N/A  
 HORN  YELLOW/BLACK (-)  in DRIVERS KICK PANEL, (BLUE, 42-PIN PLUG), PIN 25
 TACH  WHITE, (AC)  in DRIVERS KICK PANEL, (BLUE, 42-PIN PLUG), PIN 38
 WAIT TO START LIGHT  N/A  
 BRAKE  GREEN (+)  @ BRAKE PEDAL SWITCH, (4-PIN PLUG), PIN 1
 FACTORY ALARM DISARM   NOTE #4  in DRIVERS KICK PANEL, (GRAY, 39-PIN PLUG), PINS 2 and 1
 ANTI-THEFT  KIA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM, check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE STARTING you will need the 791 BYPASS Module and an Extra Ignition key. To Order the 791 go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: the BCM, (Body Control Module) is located under the DRIVERS DASH, above the BRAKE PEDAL. NOTE #3; to UNLOCK just the DRIVERS DOOR, use the BLUE (-) at the BCM, (22-PIN PLUG), PIN 16. NOTE #4: to DISARM, use the BROWN (-), this is the DOOR KEY UNLOCK wire and the YELLOW (-) this is the UNLOCK DETECTION wire, Requires Double Pulse, use both and DIODE ISOLATE. TEST both of these wires while Turning the KEY in the Drivers Door.