Vehicle
Wiring Details for your
2006-2007 Lexus IS350 Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2006-2007 Lexus IS350 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
ORANGE (+) (2 Wires) |
@ PSC ECU, 40-Pin Plug, Pins 12 and 33, See NOTE #2 |
STARTER |
LIGHT BLUE (+) |
@ PSC ECU, 40-Pin Plug, Pins 17, See NOTE #2 |
STARTER
2 |
PURPLE (+) |
@ PSC ECU, 40-Pin Plug, Pins 15, See NOTE #2 |
IGNITION
1 |
LIGHT GREEN (+) |
@ PSC ECU, 40-Pin Plug, Pins 35, See NOTE #2 |
IGNITION
2 |
PINK (+) |
@ PSC ECU, 40-Pin Plug, Pins 34, See NOTE #2 |
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
LIGHT GREEN (+) |
@ PSC ECU, 40-Pin Plug, Pins 11, See NOTE #2 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
YELLOW (-) |
@ DRIVERS SIDE FUSE BOX, 28-Pin Plug, Pin 5, See NOTE #3 |
PARKING
LIGHTS ( + ) |
BLUE (+) Front and BROWN (+) Rear, See NOTE #4 |
See DIAGRAM |
POWER LOCK |
BLUE (TYPE B) See NOTE #5 |
@ POWER WINDOW MASTER SWITCH in DRIVERS DOOR |
POWER UNLOCK |
WHITE (TYPE B) Requires Double Pulse |
@ POWER WINDOW MASTER SWITCH in DRIVERS DOOR |
DOOR TRIGGER |
See NOTE #6 |
|
DOMELIGHT
SUPERVISION |
PURPLE to PINK (-) |
@ BECU (Left Hand) 10-Pin Plug, Pin 2 |
TRUNK RELEASE |
PINK (-) |
@ TRUNK RELEASE SWITCH or BECU (Right Hand)) 28-Pin Plug, Pin 3 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
WHITE (-) |
@ HORN SWITCH under Steering Column Cover |
TACH |
WHITE |
@ DATA LINK Connector Pin 9, under drivers dash |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
RED/BLACK (+) |
@ SWITCH ABOVE BRAKE PEDAL |
FACTORY
ALARM DISARM |
DISARMS with UNLOCK |
|
ANTI-THEFT |
LEXUS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION TUMBLER |
EXTRA
INFORMATION |
NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is
required to be placed inside this module for Operation.
Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS
NO KEY is required for Operation.
To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this
website
NOTE #2: The PSC (Power Source Control) ECU is located BEHIND the GLOVEBOX.
NOTE #3: This plug is on the side of the FUSEBOX facing the firewall.
NOTE #4: To connect up (+) Positive Parking lights will require (2) extra Relays Part #775. The BLUE (+) wire controls the FRONT Parking Lights and is located at the DRIVERS SIDE HEADLIGHT and the BROWN (+) wire is for the REAR Parking lights and is located at the DRIVERS SIDE FUSE BOX, GRAY 30-Pin Plug, Pin 24.
NOTE #5: TEST the LOCK and UNLOCK wires while turning the Key in the DRIVERS DOOR KEY CYLINDER.
NOTE #6: The DRIVERS DOOR is a WHITE to RED (-) at the BECU (Right Hand), 16-Pin Plug, Pin 14. The PASSENGER DOOR is a BLACK to ORANGE (-) at the BECU (Right Hand) 28-Pin Plug, Pin 23. The DRIVERS REAR DOOR is a BROWN to ORANGE(-) at the PASSENGER SIDE FUSEBOX, 28-Pin Plug facing firewall, Pin 11. And the PASSENGER REAR DOOR is ORANGE(-) at the BECU (Right Hand), 16-Pin Plug, Pin 16. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM.
NOTE #7: The BODY ECU (Right Hand) is attached to the PASSENGER SIDE FUSE BOX behind the GLOVE BOX, the BODY ECU (Left Hand) is attached to the DRIVERS SIDE FUSE BOX under the DRIVERS SIDE of DASH.
|
|
|
|
|