NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:
(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.
(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for
Operation) 2-KEYS Required to Program Module.
To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2; this vehicle uses (2) STARTER/CRANK wires, when connecting to a Remote Starter you
must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the
Remote Starter.
NOTE #3; the BECU (Body Electronic Control Unit) is attached to the back of the FUSE BOX,
with a single 26-Pin Plug.
NOTE #4: when testing the DOOR LOCK and UNLOCK wires, you must TEST these wires when
turning the kEY in the DRIVERS DOOR KEY CYLINDER ONLY.
NOTE #5; the DRIVERS DOOR is a GREEN/YELLOW (-) in the 18-pin plug, pin 7, the
PASSENGER DOOR is a RED/BLACK (-) in a 22-pin plug, pin 8, the REAR DOORS
are a PINK/BLACK (-) in an 18-pin plug pin 6, when connecting to an ALARM SYSTEM,
use all (3) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE #6 the DATA LINK CONNECTOR is located under the DRIVERS SIDE of the DASH.
NOTE #7; THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS
BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING.
|