| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | WHITE/BLUE (+) and WHITE/RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | GREEN/BLACK (+) See NOTE #2 | @ IGNITION SWITCH HARNESS |
| STARTER 2 | BLACK/WHITE (+) See NOTE #2 | @ IGNITION SWITCH HARNESS |
| IGNITION 1 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLUE/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | WHITE/GREEN (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | GREEN/BLACK (-) | @ IGNITION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | GREEN (-) | @ HEADLIGHT SWITCH or BCEU, PIN 13, See NOTE #3 |
| PARKING LIGHTS ( + ) | GREEN (+) | @ FUSE BOX 13-Pin plug, Pin 10 |
| POWER LOCK | PURPLE (TYPE B), See NOTE #4 | IN DRIVERS KICK PANEL, 10-Pin plug, Pin 4 |
| POWER UNLOCK | GREEN/BLACK (TYPE B) (Requires Double Pulse) | IN DRIVERS KICK PANEL, 10-Pin plug, Pin 8 |
| DOOR TRIGGER | See NOTE #5 | @ FUSEBOX |
| DOMELIGHT SUPERVISION | BLUE (-), (Requires Part #775 Relay) | @ FUSEBOX, BLACK 13-Pin plug, pin 9 |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | GREEN/RED (-) | @ FUSEBOX, 18-PIN Plug, Pin 10 |
| TACH | BLACK/WHITE (AC) | @ DATA LINK CONNECTOR,pin 9, See NOTE #6 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | BLUE (+) | @ FUSEBOX, 11-PIN Plug, Pin 2 |
| FACTORY ALARM DISARM | DISARMS with KEYSENSE wire, See NOTE #7 | @ IGNITION SWITCH HARNESS |
| ANTI-THEFT | TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2; this vehicle uses (2) STARTER/CRANK wires, when connecting to a Remote Starter you must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the Remote Starter. NOTE #3; the BECU (Body Electronic Control Unit) is attached to the back of the FUSE BOX, with a single 26-Pin Plug. NOTE #4: when testing the DOOR LOCK and UNLOCK wires, you must TEST these wires when turning the kEY in the DRIVERS DOOR KEY CYLINDER ONLY. NOTE #5; the DRIVERS DOOR is a GREEN/YELLOW (-) in the 18-pin plug, pin 7, the PASSENGER DOOR is a RED/BLACK (-) in a 22-pin plug, pin 8, the REAR DOORS are a PINK/BLACK (-) in an 18-pin plug pin 6, when connecting to an ALARM SYSTEM, use all (3) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #6 the DATA LINK CONNECTOR is located under the DRIVERS SIDE of the DASH. NOTE #7; THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING. |