NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE *2 the BCM (Body Control Module) is located to the RIGHT of the STEERING COLUMN.
NOTE *3 this vehicle has 4 Door Pin Trigger wires, the DRIVERS Door is a LIGHT BLUE (-) Pin 47, the PASSENGER Door is a RED/BLUE (-) Pin 12, the DRIVERS REAR Door is a RED/YELLOW (-) Pin 48 and the PASSENGER REAR Door is a RED/WHITE or GRAY (-) Pin 13. All wires are at the BCM. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM
|