| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | GREEN (+) | IGNITION SWITCH HARNESS |
| STARTER | BROWN (+) See NOTE *1 | IGNITION SWITCH HARNESS |
| STARTER 2 | LIGHT GREEN (+) or BLUE/GREEN (+) See NOTE *1 | IGNITION SWITCH HARNESS |
| IGNITION 1 | BLACK/RED (+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | RED (+) | IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | PURPLE (+) | IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | RED/BLUE (+) | IN EITHER KICK PANEL, HARNESS to REAR of VEHICLE |
| POWER LOCK | BLUE (TYPE B) | @ DRIVERS DOOR MODULE, in DOOR, Pin 4 |
| POWER UNLOCK | RED (TYPE B) (Requires Double Pulse) | @ DRIVERS DOOR MODULE, in DOOR, Pin 6 |
| DOOR TRIGGER | See NOTE *3 | @ BCM, See NOTE *2 |
| DOMELIGHT SUPERVISION | BLUE (-) | @ BCM, Pin 63, See NOTE *2 |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | RED/WHITE (-) | @ HORN SWITCH in STEERING COLUMN |
| TACH | Any wire NOT WHITE/BLUE or BLACK | @ Any IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | RED/GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS WITH UNLOCK | |
| ANTI-THEFT | NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, Requires 791 Bypass Module and Extra Ignition Key | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 the BCM (Body Control Module) is located to the RIGHT of the STEERING COLUMN. NOTE *3 this vehicle has 4 Door Pin Trigger wires, the DRIVERS Door is a LIGHT BLUE (-) Pin 47, the PASSENGER Door is a RED/BLUE (-) Pin 12, the DRIVERS REAR Door is a RED/YELLOW (-) Pin 48 and the PASSENGER REAR Door is a RED/WHITE or GRAY (-) Pin 13. All wires are at the BCM. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM |