Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2005-2006 Jeep Wrangler . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
PART
COLOR
LOCATION
12 VOLT
CONSTANT
RED (+)
IGNITION SWITCH HARNESS
STARTER
PINK/ORANGE (+)
IGNITION SWITCH HARNESS
STARTER
2
N/A
IGNITION
1
PINK/LIGHT GREEN (+)
IGNITION SWITCH HARNESS
IGNITION
2
N/A
IGNITION
3
N/A
ACCESSORY/HEATER
BLOWER 1
PINK/YELLOW (+) (14 Gauge wire)
IGNITION SWITCH HARNESS
ACCESSORY/HEATER
BLOWER 2
N/A
KEYSENSE
N/A
PARKING
LIGHTS ( - )
N/A
PARKING
LIGHTS ( + )
WHITE/YELLOW (+)
@ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
POWER LOCK
ADD ACTUATORS
TO BOTH DOORS, See DIAGRAM
POWER UNLOCK
ADD ACTUATORS
TO BOTH DOORS, See DIAGRAM
DOOR TRIGGER
PURPLE (-) and PURPLE/YELLOW (-) Use both, See NOTE *1
IN DRIVERS KICK PANEL, See DIAGRAM
DOMELIGHT
SUPERVISION
YELLOW/ORANGE (-), Requires Part #775 Relay
@ UNDER DASH LIGHT
TRUNK RELEASE
N/A
SLIDING
POWER DOOR
N/A
HORN
RED/YELLOW (-)
IN DRIVERS KICK PANEL
TACH
Any wire NOT BROWN or PINK/GRAY
@ any FUEL-INJECTOR or IGNITION COIL
WAIT TO
START LIGHT
N/A
BRAKE
WHITE/TAN (+)
@ SWITCH ABOVE BRAKE PEDAL
FACTORY
ALARM DISARM
N/A
ANTI-THEFT
CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM
TRANSPONDER @ IGNITION SWITCH TUMBLER
EXTRA
INFORMATION
NOTE *1 this vehicle has (2) DOOR TRIGGER wires, a PURPLE (-) for the DRIVERS door and a PURPLE/YELLOW (-) for the PASSENGER door. When connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM