Jeep  Wrangler 2005-2006
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   IGNITION SWITCH HARNESS
 STARTER  PINK/ORANGE (+)  IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  PINK/LIGHT GREEN (+)  IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  PINK/YELLOW (+) (14 Gauge wire)  IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  WHITE/YELLOW (+)  @ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
 POWER LOCK  ADD ACTUATORS  TO BOTH DOORS, See DIAGRAM
 POWER UNLOCK  ADD ACTUATORS  TO BOTH DOORS, See DIAGRAM
 DOOR TRIGGER  PURPLE (-) and PURPLE/YELLOW (-) Use both, See NOTE *1  IN DRIVERS KICK PANEL, See DIAGRAM
 DOMELIGHT SUPERVISION  YELLOW/ORANGE (-), Requires Part #775 Relay  @ UNDER DASH LIGHT
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  N/A  
 HORN  RED/YELLOW (-)  IN DRIVERS KICK PANEL
 TACH  Any wire NOT BROWN or PINK/GRAY  @ any FUEL-INJECTOR or IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE/TAN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   N/A  
 ANTI-THEFT  CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM  TRANSPONDER @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE *1 this vehicle has (2) DOOR TRIGGER wires, a PURPLE (-) for the DRIVERS door and a PURPLE/YELLOW (-) for the PASSENGER door. When connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM