Vehicle
Wiring Details for your
2004-2009 Volkswagen Touareg Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2009 Volkswagen Touareg . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) 150 AMP |
@ DRIVERS DASH FUSE BOX |
| STARTER |
BLACK or RED (+) (NOT for REMOTE START) |
@ STARTER or STARTER RELAY @ UNDERHOOD FUSE BOX |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLACK (+) (NOT for REMOTE START) |
@ DRIVERS DASH FUSE BOX |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
GREEN/YELLOW (-) |
@ VESCM, (26-PIN PLUG), PIN 5, NOTE #2 |
| PARKING
LIGHTS ( + ) |
GRAY/BLACK(+)(Left Front) and GRAY/RED(+)(Right Front), NOTE #4 |
@ VESCM, (BROWN, 6-PIN PLUG), PIN 4 and (BLUE, 6-PIN PLUG), PIN 5, NOTE #2 |
| POWER LOCK |
YELLOW (-) thru a 780 Ohm Resistor, NOTE #5 |
@ DDM, (GRAY, 32-PIN PLUG), PIN 6, NOTE #6 |
| POWER UNLOCK |
Use LOCK wire, (-) |
|
| DOOR TRIGGER |
RED/BLUE (-) |
@ DDM, (BLACK, 12-PIN PLUG), PIN 2, NOTE #6 |
| DOMELIGHT
SUPERVISION |
BLUE/WHITE (-) |
@ VESCM, (WHITE, 6-PIN PLUG), PIN 2, NOTE #2 |
| TRUNK RELEASE |
PURPLE/GREEN (-) (Liftgate), NOTE #7 |
@ DDM, (GRAY, 32-PIN PLUG), PIN 23, NOTE #6 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
PURPLE (+) |
@ VESCM, (4-PIN PLUG), PIN 1, NOTE #2 |
| TACH |
NOTE #9 |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/RED (+) |
@ BRAKE PEDAL SWITCH, (4-PIN PLUG), PIN 4 |
| FACTORY
ALARM DISARM |
BLUE/YELLOW (-) thru a 250 Ohm Resistor, NOTE #10 |
@ DDM, (BLACK, 12-PIN PLUG), PIN 8, NOTE #6 |
| ANTI-THEFT |
VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
MUST USE, Part # DLPK + RFLUB antenna loop, for REMOTE START/DOOR LOCKS
NOTE #2: the VESCM, (Vehicle Electrical System Control Module) is Under the DRIVERS DASH
above the Gas Pedal.
NOTE #4: when using the (+) PARKING LIGHT wire, the LEFT REAR and RIGHT REAR wires are
GRAY (+) at the CSCM, (12-PIN PLUG) PIN 10 and (12-PIN PLUG), PIN 5. Use all 4
wires and ISOLATE with Relays.
NOTE #5: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for
operation. The use of Bypass Module DLPK will do the
ANTI-THEFT and DOOR LOCKS without the use of relays and resistors.
NOTE #6; the DDM, (Drivers Door Module) is located in the DRIVERS DOOR
NOTE #7: the LIFTGATE GLASS Release is a YELLOW (-) at the CSCM, (23-PIN PLUG), PIN 3.
NOTE #8: the CSCM, (Confort System Control Module) is located in the RIGHT REAR QUARTER
PANEL.
NOTE #9: when using the TACH wire, use any BROWN STRIPE wire (V8) and
NON-COMMON wire (V6), tests (AC)
NOTE #10: TEST this wire while Turning the KEY in the DRIVERS DOOR. On some models this wire
only controls the Locks and windows it will not control the Factory Alarm.
|
|
|
|
|
|
