NOTE #1: If you vehicle has the ANTI-THEFT KEY, a INTERFACE BYPASS MODULE Part # DB-ALL or
XK09 that will BYPASS the ANTI-THEFT SYSTEM and it will also bypass the need for the
resistors on the door locks, to order please go to the INTERFACE BYPASS MODULE
page on this website
NOTE #2: This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive thru a
2700 Ohm Resistor to LOCK and a (+)Positive thru a 620 Ohm Resistor to UNLOCK,
some units will also require 2 extra relays part #775 to connect, See DIAGRAM
NOTE #3: To DISARM requires a (+)Positive thru a 750 Ohm Resistor and an extra Relay part
#775 to connect, See DIAGRAM
NOTE #4; The BCM (Body Control Module) is located under the DRIVERS SIDE of DASH and is
attached to the FUSE/RELAY box. Connector 4 is a 26 pin plug at the bottom edge of
the BCM.
NOTE #5: this vehicle uses 4 door pin triggers, at the BCM Connector 4, the DRIVERS DOOR is a
TAN (-) Pin 5, the PASSENGERS DOOR is a TAN/RED (-) Pin 6, the DRIVERS REAR
DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW,
Pin 8. When connecting to an ALARM SYSTEM, use all 4 wires and DIODE ISOLATE.
See DIAGRAM
NOTE #6: the TRUNK/HATCH Release on this vehicle is a 5-Wire System and will require an
extra Relay Part #775, to connect, See DIAGRAM.
|