| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: the PARKING LIGHTS require an extra relay Part #775 and a (-)Negative thru a 47
Ohm Resistor, to connect, See DIAGRAM
NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to
LOCK and a (+)Positive thru a 620 Ohm resistor to UNLOCK, some units will also
require 2 extra relays part #775 for the keyless entry feature to function, See
DIAGRAMS.You can also get a INTERFACE BYPASS MODULE the Part # XK09 that will
do this for you without adding extra relays and resistors, these Modules will also do
dome light supervision and trunk pop with nothing needed, to order please go to the
INTERFACE BYPASS MODULE Page on this website
NOTE #4: The BCM (Body Control Module) is located on the LEFT SIDE of the dash attached to
the JUNCTION BLACK.
NOTE #5: This vehicle uses a Multi-Coil system, for TACH use any wire at the coil pack that is
NOT DARK GREEN/LIGHT GREEN
NOTE #6: the DRIVERS DOOR is a TAN (-) PIN 4, the PASSENGER DOOR is a TAN/RED (-) PIN 2,
the DRIVERS REAR DOOR is a TAN/RED (-) PIN 1 and the PASSENGER REAR DOOR is a
TAN/RED (-) PIN 10. When connecting to an ALARM SYSTEM, use all 4 wires and
DIODE ISOLATE See DIAGRAM
NOTE #7: the DISARM wire requires an extra relay part #775 and a (+)Positive thru a 680 Ohm
Resistor, to connect, See DIAGRAM.
|
