| NOTE #1: This vehicle requires an Interface Module Part# XK09 or GMDL-BP to
connect the keyless entry AND bypass the PASSLOCK 2 System. If NOT installing
keyless entry use the 791 bypass module instead. To order go to the security/interface bypass module
page on this website.
NOTE #2: The BCM (Body Control Module) is located behind the drivers side of the dash,
with the plugs facing the rear of the vehicle.
NOTE #3: This vehicle use (2) door pin triggers, the DRIVERS DOOR is a GREY/BLACK (-) at
the DRIVERS DOOR module in the DRIVERS DOOR. The PASSENGER DOOR is a
BLACK/WHITE (-) at the PASSENGERS DOOR module in the PASSENGERS DOOR.
The DRIVERS REAR DOOR is a LIGHT BLUE/BLACK (-) Pin A3 and the PASSENGERS
REAR DOOR is a LIGHT GREEN/BLACK (-) Pin A2, both are located at the BCM,
PURPLE plug. When connecting to an ALARM SYSTEM, use all 4 Door Trigger wires
and DIODE ISOLATE. to connect, See DIAGRAM
NOTE #4 The PCM (Power Control Module) is located in the LEFT front of the engine
compartment to the LEFT of the fan shroud. The TACH wire is in a GREEN Plug Pin 10.
NOTE #5: IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2
for REMOTE STARTING!!!!!!