PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | WHITE (+), See NOTE #5 | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | LIGHT GREEN (-) | @ IGNITION SWITCH HARNESS |
PARKING LIGHTS ( - ) | GRAY/BLACK (-) | @ BCM, BROWN Plug, Pin B2, See NOTE #2 |
PARKING LIGHTS ( + ) | BROWN (+) | IN DRIVERS KICK PANEL |
POWER LOCK | See NOTE #1 | |
POWER UNLOCK | See NOTE #1 | |
DOOR TRIGGER | See NOTE #3 | @ BCM, See NOTE #2 |
DOMELIGHT SUPERVISION | GRAY/BLACK (-) | @ BCM, BLACK Plug, Pin E, See NOTE #2 |
TRUNK RELEASE | N/A | |
SLIDING POWER DOOR | N/A | |
HORN | BLACK/YELLOW to BLACK (-) | @ BCM, GRAY plug, Pin B9, See NOTE #2 |
TACH | WHITE (AC) | @ PCM, GREEN plug, Pin 10, See NOTE #4 |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN (-) | in DRIVERS DOOR MODULE in DRIVERS DOOR |
ANTI-THEFT | YELLOW (+), BLACK (-) and RED/WHITE (Not Used) | GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column. |
EXTRA INFORMATION |
NOTE #1: This vehicle requires an Interface Module Part# XK09 or GMDL-BP to connect the keyless entry AND bypass the PASSLOCK 2 System. If NOT installing keyless entry use the 791 bypass module instead. To order go to the security/interface bypass module page on this website. NOTE #2: The BCM (Body Control Module) is located behind the drivers side of the dash, with the plugs facing the rear of the vehicle. NOTE #3: This vehicle use (2) door pin triggers, the DRIVERS DOOR is a GREY/BLACK (-) at the DRIVERS DOOR module in the DRIVERS DOOR. The PASSENGER DOOR is a BLACK/WHITE (-) at the PASSENGERS DOOR module in the PASSENGERS DOOR. The DRIVERS REAR DOOR is a LIGHT BLUE/BLACK (-) Pin A3 and the PASSENGERS REAR DOOR is a LIGHT GREEN/BLACK (-) Pin A2, both are located at the BCM, PURPLE plug. When connecting to an ALARM SYSTEM, use all 4 Door Trigger wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE #4 The PCM (Power Control Module) is located in the LEFT front of the engine compartment to the LEFT of the fan shroud. The TACH wire is in a GREEN Plug Pin 10. NOTE #5: IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!! |