PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/BLUE (+)	IGNITION SWITCH HARNESS
STARTER	RED/WHITE (+) or WHITE/RED (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	WHITE/GREEN (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/BLUE (+)	IN DRIVERS KICK PANEL, HARNESS heading to REAR of Vehicle
POWER LOCK	YELLOW (Negative (-)) See NOTE *2	@ DRIVERS DOOR MODULE in DRIVERS DOOR
POWER UNLOCK	LIGHT BLUE (Negative (-)) Requires Double Pulse See NOTE *2	@ DRIVERS DOOR MODULE in DRIVERS DOOR
DOOR TRIGGER	YELLOW (-) and PINK (-) Use both, See NOTE *3	@ BCM, WHITE 12 PIN PLUG, See NOTE *4
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	PINK (-)	@ BCM, BROWN PLUG, PIN 76, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK (-)	@ STEERING COLUMN HARNESS
TACH	ANY WIRE NOT BLACK or WHITE/BLUE	@ ANY IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	PINK/BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse Disarms
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 TEST THESE WIRES WHILE TURNING THE KEY IN THE DRIVER DOOR KEY CYLINDER. NOTE *3 THE DRIVERS DOOR IS A YELLOW (-) PIN 14, THE PASSENGER DOOR IS A PINK (-) PIN 10. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM NOTE *4 THE BCM (BODY CONTROL MODULE) IS LOCATED IN THE DRIVERS KICK PANEL, THE BCM HAS 4 WHITE PLUGS AND 1 BROWN PLUG.