PART	COLOR	LOCATION
12 VOLT CONSTANT	BROWN (+) and LIGHT GREEN (+)	IGNITION SWITCH HARNESS
STARTER	RED/LIGHT BLUE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	WHITE/YELLOW (+)	IGNITION SWITCH HARNESS
IGNITION 2	PINK/BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	GRAY/YELLOW (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/GREEN (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE/BLACK (-)	@ LCM, GRAY 16-Pin Plug, Pin 13, See NOTE *2
PARKING LIGHTS ( + )	BROWN (+)	@ LCM, BLACK Plug, Pin 4, See NOTE *2
POWER LOCK	PINK/YELLOW (5 Wire Reverse Polarity) See NOTE *1	IN DRIVERS DOOR HARNESS
POWER UNLOCK	PINK/LIGHT GREEN (5 Wire Reverse Polarity) See NOTE *1	IN DRIVERS DOOR HARNESS
DOOR TRIGGER	DARK BLUE (-) and BLACK/ORANGE (-) Use both See NOTE *4	@ LCM, See NOTE *2
DOMELIGHT SUPERVISION	DARK BLUE (-), Requires Part #R30-H Relay	@ LCM, See NOTE *2
TRUNK RELEASE	PURPLE/YELLOW (5-Wire) See NOTE *3, Requires Part #R30-H Relay	IN DRIVERS DOOR HARNESS
SLIDING POWER DOOR	N/A
HORN	DARK BLUE (-)	@ STEERING COLUMN HARNESS
TACH	Any wire that is NOT RED or RED/LIGHT GREEN	@ IGNITION COIL or FUEL INJECTOR
WAIT TO START LIGHT
BRAKE	LIGHT GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	FORD'S SECURILOCK ANTI-THEFT SYSTEM, TRANSPONDER	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 If vehicle is equipped with a FACTORY KEYLESS ENTRY System, then the vehicle has a Negative (-) Door Locking System, vehicles without FACTORY KEYLESS ENTRY, have a 5 Wire Reverse Polarity Door Locking System. Vehicles with the KEY PAD on the Door is considered to have KEYLESS ENTRY. NOTE *2 The LCM (Lighting Control Module) is located to the RIGHT of the STEERING COLUMN, with its harness accessable between the steering column and the LCM. NOTE *3 This vehicle uses a 5-Wire TRUNK RELEASE SYSTEM, and will require an extra relay part #R30-H, to connect, See DIAGRAM. NOTE *4 this vehicle has 2 DOOR TRIGGER wires, when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM.