Chevrolet  S-10 Pick-Up 1998-2004
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  YELLOW (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  PINK (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  WHITE (+) SEE NOTE #2  @ IGNITION SWITCH HARNESS
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BROWN (+)  @ HEADLIGHT SWITCH or BCM, LT. BLUE PLUG, SEE NOTE #3
 POWER LOCK  LT. BLUE (TYPE A)  @ BCM, BROWN PLUG, SEE NOTE #3
 POWER UNLOCK  WHITE (TYPE A)  @ BCM, BROWN PLUG, SEE NOTE #3
 DOOR TRIGGER  SEE NOTE #4  @ BCM, SEE NOTE #3
 DOMELIGHT SUPERVISION  TAN (-)  @ BCM, PURPLE PLUG, PIN B4, SEE NOTE #3
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  N/A  
 HORN  BLACK (-)  @ STEERING COLUMN HARNESS
 TACH  WHITE (AC)  @ PCM, SEE NOTE #5
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE (+)  @ BRAKE PEDAL SWITCH or STEERING COLUMN
 FACTORY ALARM DISARM   N/A  
 ANTI-THEFT  GM'S PASSLOCK 2 ANTI-THEFT SYSTEM, SEE NOTE #1  WIRES AT IGNITION SWITCH
 EXTRA INFORMATION
 NOTE #1; This vehicle uses GM's PASSLOCK 2 ANTI-THEFT SYSTEM and requires the 791 Bypass Module to REMOTE START, to order please go to the SECURITY BYPASS MODULES page on this website. NOTE #2: The IGNITION #2 wire MUST be connected to prevent an CHECK ENGINE LIGHT and prevent DAMAGE to the AUTOMATIC TRANSMISSION. NOTE #3: The BCM is located to the right of the GAS Pedal, below the Radio, the plugs on the BCM, face the drivers side of the vehicle. NOTE #4: Use TAN (-) for the Drivers door, PURPLE PLUG, PIN B4, ORANGE (-) for the Passengers door, PURPLE PLUG, PIN B2, when installing an Alarm use both wires and diode isolate. NOTE #5: The PCM is located on the Passanger side fender. For the 2.2L Engine the wire is located in a BLACK 8-PIN PLUG, PIN 10. On the 4.3L Engine, the wire is in a RED, 32-PIN PLUG, PIN 20.