PART	COLOR	LOCATION
12 VOLT CONSTANT	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER	RED/LIGHT BLUE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	LIGHT GREEN/PURPLE (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BROWN (+) (2 BROWN wires)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BROWN (+) (Use BOTH)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	WHITE/PURPLE (-)	@ CSM BEHIND GLOVE BOX
PARKING LIGHTS ( + )	WHITE/BLACK (+) or BROWN (+)	@ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
POWER LOCK	PINK/YELLOW (5 Wire Reverse Polarity) See NOTE *1	IN DRIVERS KICK PANEL
POWER UNLOCK	PINK/LIGHT GREEN (5 Wire Reverse Polarity) See NOTE *1	IN DRIVERS KICK PANEL, See NOTE *1
DOOR TRIGGER	YELLOW/BLACK (-) and GRAY/RED (-) Use both, See NOTE *3, Requires Part #R30-H Relay	IN EACH DOOR HARNESS, See DIAGRAM
DOMELIGHT SUPERVISION	YELLOW/BLACK (-), Requires Part #R30-H Relay	IN DRIVERS DOOR HARNESS
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	YELLOW/LIGHT GREEN (-)	@ STEERING COLUMN HARNESS
TACH	TAN/YELLOW	@ PCM, See NOTE *2
WAIT TO START LIGHT	N/A
BRAKE	LIGHT GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DARK GREEN/PURPLE (-)	IN DRIVERS KICK PANEL
ANTI-THEFT	FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 On some vehicle with FACTORY ALARM or KEYLESS ENTRY, after the vehicle sets for a few minutes, if you cannot UNLOCK the door with the AFTERMARKET remote control it will be necessary to WAKE UP the GEM Module. See DIAGRAM under DOOR UNLOCK, GEM WAKE UP DIAGRAM. IF the vehicle DOES NOT HAVE a FACTORY KEYLESS ENTRY or FACTORY ALARM it is a 5 Wire Reverse Polarity Door Locking System. NOTE *2 The PCM (Power Control Module) is located at the TOP of the FIREWALL towards the PASSENGER side. You can also use any wire at the COIL PACK with a TAN STRIPE. NOTE *3 This vehicle has 2 door triggers, when connecting to an ALARM SYSTEM use both wires and DIODE ISOLATE. to connect, See DIAGRAM.