NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: this vehicle uses a 1-Wire Door Locking System, the LOCK requires a (+)Positive
thru a 620 Ohm Resistor and the UNLOCK requires a (+)Positive thru a 2700 Ohm
Resistor, some units will also require 2 extra relays Part #775, to connect,
See DIAGRAM
NOTE #3; the DRIVERS DOOR is a TAN (-) Pin 5 the PASSENGER DOOR is a TAN/RED (-) Pin 6
the DRIVERS REAR DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR
is a TAN/YELLOW (-) Pin 8 when connecting to an ALARM SYSTEM use all 4 DOOR
TRIGGER wires and DIODE ISOLATE. to connect, See DAIGRAM
NOTE #4; the BCM (Body Control Module) is attached to FUSE/RELAY BOX located under
the drivers side of the dash
NOTE #5: the FACTORY DISARM wire requires a (+)Positive thru a 750 ohm Resistor and
an extra relay part #775, to connect, See DIAGRAM
NOTE #6; the TRUNK RELEASE System on this vehicle is a 5-Wire Type and will require an
extra Relay part #775, to connect, See DIAGRAM.
|