PART | COLOR | LOCATION |
12 VOLT CONSTANT | PINK/BLACK (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | BLUE (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | GREEN/RED (+) (20 Gauge wire, 1 of 2, use the one that tests as Ignition) | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | BLACK/ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | BLACK/WHITE (+) or BLACK/BLUE (+) (Normally not used) | @ IGNITION SWITCH HARNESS |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | BLACK/YELLOW (+) | IN DRIVERS KICK PANEL |
POWER LOCK | WHITE/DARK GREEN (1-Wire Door Lock System), See NOTE #2 | @ BCM, Connector C4 Pin 15, See NOTE #4 |
POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAM |
DOOR TRIGGER | See NOTE #3 | @ BCM, See NOTE #4 |
DOMELIGHT SUPERVISION | YELLOW (-), (Requires Part #775 Relay) | @ FRONT of FUSEBOX, 6-Pin Plug |
TRUNK RELEASE | BLACK/WHITE (5-Wire), See NOTE #6 | @ BCM, Connector C4, Pin 1, See NOTE #4 |
SLIDING POWER DOOR | N/A | |
HORN | BLACK/RED (-) | @ STEERING COLUMN HARNESS |
TACH | ANY wire NOT GREEN/LIGHT GREEN (AC) | @ COIL PACK |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN/ORANGE (+) See NOTE #5 | @ BCM, Connector C4, Pin 4, See NOTE #4 |
ANTI-THEFT | CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1 | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: this vehicle uses a 1-Wire Door Locking System, the LOCK requires a (+)Positive thru a 620 Ohm Resistor and the UNLOCK requires a (+)Positive thru a 2700 Ohm Resistor, some units will also require 2 extra relays Part #775, to connect, See DIAGRAM NOTE #3; the DRIVERS DOOR is a TAN (-) Pin 5 the PASSENGER DOOR is a TAN/RED (-) Pin 6 the DRIVERS REAR DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW (-) Pin 8 when connecting to an ALARM SYSTEM use all 4 DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DAIGRAM NOTE #4; the BCM (Body Control Module) is attached to FUSE/RELAY BOX located under the drivers side of the dash NOTE #5: the FACTORY DISARM wire requires a (+)Positive thru a 750 ohm Resistor and an extra relay part #775, to connect, See DIAGRAM NOTE #6; the TRUNK RELEASE System on this vehicle is a 5-Wire Type and will require an extra Relay part #775, to connect, See DIAGRAM. |