NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: the CTM (Central Timmer Module) is located in the DRIVERS KICK PANEL.
NOTE #3: this vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a
820 Ohm Resistor and UNLOCK requires a (-)Negative thru a 330 Ohm Resistor,
some units will also require 2 extra relays part #775, to connect, See DIAGRAM
NOTE #4: the DRIVERS DOOR is a TAN (-) at Pin 15, the PASSENGER DOOR (and the REAR
DOORS if a 4 DOOR) is a TAN/RED (-) at Pin 13. When connecting to an ALARM
SYSTEM use all wires and DIODE ISOLATE. See DIAGRAM
NOTE #5: on the 2.5L, 3.9L, and 5.9L engines use the BLACK/GREY wire at the IGNITION COIL
for the TACH wire. on the 4.7L engine use the wire that is NOT a GREEN/ORANGE at
the coil.
NOTE #6: this wire DISARMS the vehicle when a (-) Negative thru a 1565 Ohm resistor on this
wire will DISARM it will also require an extra relay part #775 to connect. See DIAGRAM
NOTE #7: the IGNITION #3 wire must be isolated using a Relay Part #775 to prevent the
CHECK ENGINE light from turning on during Remote Starting. See DIAGRAM
|