NOTE *1 This vehicle has (2) Positive Parking Light wires, GRAY/BLACK Left and GRAY/RED Right, that will require adding 2 Extra relays Part #775 to connect, See DIAGRAM.
NOTE *2 The ILLUMINATION CONTROL Module is attached to the HEADLIGHT Switch in the vehicle.
NOTE *3 This vehicle uses a 1-Wire Door Locking System, to LOCK requires a straight (-) Negative or Ground, and the UNLOCK is a (-) Negative or Ground thru a Resistor, you will need to meter this wire to see the Required resistor on the Vehicle. To TEST the LOCK/UNLOCK wire use the Door Lock switch on the dash.
NOTE *4 The PSE Control Module is located in the PASSENGER side of the Trunk.
NOTE *5 This vehicle has (2) Door Trigger wires, the DRIVERS DOOR Trigger is a BROWN/GRAY (-) and the PASSENGER DOOR Trigger is a BROWN/BLUE (-), when connecting to an Alarm System, use both wires and DIODE ISOLATE, to connect See DIAGRAM.
NOTE *6 TEST the Trunk release wire while turning the trunk release handle.
NOTE *7 TEST this wire while Turning the Key in the Drivers Door Key Cylinder.
|