| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) (X3) | @ IGNITION SWITCH HARNESS |
| STARTER | PURPLE (+) Not for Remote Starting! | |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | PINK/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | BLACK/GREEN (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 1 | N/A | |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | See NOTE *1 | @ ILLUMINATION CONTROL MODULE, See NOTE *2 |
| POWER LOCK | WHITE/GREEN (TYPE B) See NOTE *3 | @ PSE Control Module, 16-Pin Plug, Pin 6, See NOTE *4 |
| POWER UNLOCK | Same wire! | |
| DOOR TRIGGER | See NOTE *5 | @ PSE Control Module, 18-Pin Plug, Pins 14 and 16, See NOTE *4 |
| DOMELIGHT SUPERVISION | Use Door Trigger wire! | |
| TRUNK RELEASE | YELLOW (-), See NOTE *6 | @ PSE Control Module, 18-Pin Plug, Pin 5, See NOTE *4 |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/WHITE (+) | @ HORNS under the HOOD |
| TACH | Any wire NOT: BLACK/GREEN or BLACK/YELLOW | @ Any IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | BLACK, BLACK/RED or BLACK/PURPLE (+) | @ ILLUMINATION CONTROL MODULE, See NOTE *2 |
| FACTORY ALARM DISARM | BLUE (-) See NOTE *7 | @ DRIVERS DOOR Module in Drivers Door |
| ANTI-THEFT | MERCEDES TRANPONDER ANTI-THEFT System, Requires Extra Programmed Ignition Key and 791 Bypass Module | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 This vehicle has (2) Positive Parking Light wires, GRAY/BLACK Left and GRAY/RED Right, that will require adding 2 Extra relays Part #775 to connect, See DIAGRAM. NOTE *2 The ILLUMINATION CONTROL Module is attached to the HEADLIGHT Switch in the vehicle. NOTE *3 This vehicle uses a 1-Wire Door Locking System, to LOCK requires a straight (-) Negative or Ground, and the UNLOCK is a (-) Negative or Ground thru a Resistor, you will need to meter this wire to see the Required resistor on the Vehicle. To TEST the LOCK/UNLOCK wire use the Door Lock switch on the dash. NOTE *4 The PSE Control Module is located in the PASSENGER side of the Trunk. NOTE *5 This vehicle has (2) Door Trigger wires, the DRIVERS DOOR Trigger is a BROWN/GRAY (-) and the PASSENGER DOOR Trigger is a BROWN/BLUE (-), when connecting to an Alarm System, use both wires and DIODE ISOLATE, to connect See DIAGRAM. NOTE *6 TEST the Trunk release wire while turning the trunk release handle. NOTE *7 TEST this wire while Turning the Key in the Drivers Door Key Cylinder. |