NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2; the BCM (Body Control Module) is located in the DRIVERS KICK PANEL. Connector 1 is
WHITE, and on TOP with plug towards the FRONT of the vehicle, Connector 2 is
WHITE, and on TOP with plug towards the REAR of vehicle. Connector 3 is BLACK and
at the BOTTOM.
NOTE #3: CAUTION!!!! The REAR of the CONVERTIBLE TOP must be UNLATCHED and FOLDED
forward BEFORE using the TRUNK RELEASE.
NOTE #4: A (-) Negative thru a 663 Ohm Resistor will DISARM the Factory Security without
UNLOCKING the doors.
NOTE #5: When connecting to an ALARM SYSTEM use both wires and DIODE ISOLATE, to
connect, See DIAGRAM
|