NOTE #1: This vehicle is equipped with CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM and
will require the 791 bypass module and and extra ignition key for remote starting
only. to order go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the PARKING LIGHTS on this vehicle Require an extra Relay part #775 and a
(-)Negative thru a 110 Ohm Resistor, See DIAGRAM
NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to
Lock and a (+)Positive thru a 620 Ohm resistor to Unlock, some units will also
require extra relays for the keyless entry feature See DIAGRAMS.
NOTE #4; The BCM (Body Control Module) is located under the left side of the dash, along side
the JUNCTION BLOCK.
NOTE #5: This vehicle uses a Multi-Coil Ignition system, at the Coil use any wire that has a
TAN STRIPE for the TACH wire.
NOTE #6: the DISARM wire on this vehicle requires a (+)Positive thru an extra Relay Part #775
and a 680 Ohm resistor, See DIAGRAM
NOTE #7: this vehicle has 2 Door Trigger wires, when connecting to an ALARM SYSTEM, use
both and DIODE ISOLATE, See DIAGRAM.
|