PART | COLOR | LOCATION |
12 VOLT CONSTANT | PINK/BLACK (+) or RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | DARK BLUE/WHITE (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | GREEN/RED (+) | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | BLACK/ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | YELLOW (-), See NOTE #2 | @ HEADLIGHT SWITCH, See DIAGRAM |
PARKING LIGHTS ( + ) | N/A | |
POWER LOCK | WHITE/GREEN (1-Wire Door System), See NOTE #3 | @ BACK of FUSEBOX, See DIAGRAM |
POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAMS |
DOOR TRIGGER | TAN (-) and TAN/RED (-) use both, See NOTE #7 | @ BCM, See NOTE #4 |
DOMELIGHT SUPERVISION | YELLOW (-), (Requires #775 Relay) | @ REAR of FUSEBOX, in a BROWN Plug |
TRUNK RELEASE | BLACK/WHITE (+), (Requires #775 Relay) | @ TRUCK RELEASE SWITCH |
SLIDING POWER DOOR | N/A | |
HORN | BLACK/RED (-) | @ STEERING COLUMN HARNESS |
TACH | See NOTE #5 | |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN/ORANGE (+), See NOTE #6 | IN DRIVERS KICK PANEL, See DIAGRAM |
ANTI-THEFT | CHRYSLER'S SENTRY ANTI-THEFT TRANSPONDER System, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: This vehicle is equipped with CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM and will require the 791 bypass module and and extra ignition key for remote starting only. to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: the PARKING LIGHTS on this vehicle Require an extra Relay part #775 and a (-)Negative thru a 110 Ohm Resistor, See DIAGRAM NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to Lock and a (+)Positive thru a 620 Ohm resistor to Unlock, some units will also require extra relays for the keyless entry feature See DIAGRAMS. NOTE #4; The BCM (Body Control Module) is located under the left side of the dash, along side the JUNCTION BLOCK. NOTE #5: This vehicle uses a Multi-Coil Ignition system, at the Coil use any wire that has a TAN STRIPE for the TACH wire. NOTE #6: the DISARM wire on this vehicle requires a (+)Positive thru an extra Relay Part #775 and a 680 Ohm resistor, See DIAGRAM NOTE #7: this vehicle has 2 Door Trigger wires, when connecting to an ALARM SYSTEM, use both and DIODE ISOLATE, See DIAGRAM. |