PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	PURPLE (+) or YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	PINK/WHITE (+) or WHITE (+) See NOTE *3	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH
POWER LOCK	LIGHT BLUE (TYPE A) See NOTE *1	IN EITHER DOOR HARNESS
POWER UNLOCK	WHITE (TYPE A) See NOTE *1	IN EITHER DOOR HARNESS
DOOR TRIGGER	PURPLE (-)	@ HEADLIGHT SWITCH
DOMELIGHT SUPERVISION	WHITE (-), Requires #775 Relay	@ HEADLIGHT SWITCH
TRUNK RELEASE	BLACK (+), Requires #775 Relay	@ HATCH RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	PURPLE/WHITE	@ ECM, See NOTE *2
WAIT TO START LIGHT	DARK BLUE (+) See NOTE *4	@ INSTRUMENT CLUSTER
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	N/A

EXTRA INFORMATION

NOTE *1 If vehicle is a 2-Door, the Door Locking System is a TYPE "C", If vehicle is a 4-Door, the Door Locking System is a TYPE "A". NOTE *2 The ECM (Engine Control Module) is located behind the GLOVEBOX and to the RIGHT NOTE *3 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!! NOTE *4 when hooking up a REMOTE STARTER on a DIESEL, if the WAIT to START wire from the Remote Starter does not wait until the Light on the dash turn out before cranking, you will need to program in the 5,10 or 15 Second WAIT to START TIMMER in the Installation Manual. On some vehicles the Wait to Start Light on the dash is not a true (+)Positive or (-)Negative and the wire from the Remote Starter will not work. When this Wait to Start Timmer is programmed, disconnect and tape up the Wait to Start wire from the Remote Starter that is tied into the Wait to Start Light on the dash.