Honda Pilot 2009-2011 Printer Friendly Wiring Chart

Honda Pilot 2009-2011

PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE (+)	@ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 2
STARTER	YELLOW (+)	@ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 1
STARTER 2	N/A
IGNITION 1	PINK (+)	@ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 5
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	@ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 3
ACCESSORY/HEATER BLOWER 2	RED (+)	@ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 4
KEYSENSE	N/A
PARKING LIGHTS ( - )	GRAY (-) (REQUIRES #775 RELAY)	@ HEADLIGHT SWITCH, (BLACK/WHITE, 12-Pin Plug) Pin 11
PARKING LIGHTS ( + )	GRAY (+)	@ DASH FUSE BOX, (LT. GREEN, 42-Pin Plug) Pin 19
POWER LOCK	PINK (TYPE B), See NOTE #2	@ POWER WINDOW Master Switch, (GRAY, 37-Pin Plug) Pin 28
POWER UNLOCK	WHITE (-) and RED (-) TYPE B, (DOUBLE PULSE Required), See NOTE #2	@ POWER WINDOW Master Switch, (GRAY, 37-Pin Plug) Pins 29 and 31
DOOR TRIGGER	YELLOW (-)	@ DASH FUSE BOX, (LT. GREEN, 42-Pin Plug) Pin 37
DOMELIGHT SUPERVISION	PINK (-)	Above DRIVERS KICK PANEL, (GRAY, 2-Pin Plug) Pin 1
TRUNK RELEASE	ORANGE (-) (Liftgate) NOTE #3 and #4	@ DASH FUSE BOX, (LT. GREEN, 42-Pin Plug) Pin 13
SLIDING POWER DOOR	N/A
HORN	GRAY (-)	@ HORN SWITCH, (WHITE, 20-Pin Plug) Pin 1
TACH	Any wire NOT YELLOW/BLACK (AC)	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	LIGHT BLUE (+)	@ BRAKE SWITCH or DASH FUSE BOX, (LT. GREEN, 42-Pin Plug) Pin 34
FACTORY ALARM DISARM	DISARMS with UNLOCK
ANTI-THEFT	HONDA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1: HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. (For Remote Starting/Door Locks) Part # DB-ALL (No Extra Key Required for Operation) 1-KEY Required for Programming. To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: METER THE DOORLOCK WIRES WHILE TURNING THE KEY IN THE DRIVERS DOOR CYLINDER. WHITE IS THE DRIVER DOOR KEY CYLINDER, WHITE IS THE UNLOCK WIRE AND THE RED IS THE DOOR UNLOCK DETECTION WIRE. USE BOTH WIRES AND DIODE ISOLATE EACH. NOTE #3: THE HATCH GLASS RELEASE WIRE, IS A PINK (-) LOCATED IN THE DRIVERS KICK PANEL, AT A WHITE, 18-PIN PLUG, PIN 8. TEST THESE WIRES WHILE OPENING THE LIFTGATE/HATCH GLASS FROM THE HANDLE ON THE REAR OF THE VEHICLE. NOTE #4: ON VEHICLES WITH POWER TAILGATE, THE OPEN/CLOSE WIRES ARE BROWN (SWITCH) AND PURPLE to WHITE (COMMON), ABOVE THE DRIVERS KICK PANEL, IN A WHITE,24-PIN PLUG, PINS 20 AND 9. THESE WIRES SHORT WHEN THE SWITCH IS PRESSED.