Honda  Accord  2009-2011
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   WHITE (+)   @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 2
 STARTER  YELLOW (+)  @ IGNITION SWITCH, (WHITE, 5-Pin Plug) Pin 1
 STARTER 2  N/A  
 IGNITION 1  BLUE (+)  @ IGNITION SWITCH, (WHITE,5-Pin Plug) Pin 5
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+)  @ IGNITION SWITCH, (WHITE,5-Pin Plug) Pin 3
 ACCESSORY/HEATER BLOWER 2  RED(+)  @ IGNITION SWITCH, (WHITE,5-Pin Plug) Pin 4
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  GRAY (-)  @ HEADLIGHT SWITCH, (BLACK/WHITE, 12-Pin Plug) Pin 11
 PARKING LIGHTS ( + )  RED (+) (Left Front and Left Rear) Note #2  @ DRIVERS DASH FUSE BOX, (LT. GREEN, 16-Pin Plug) Pin 11
 POWER LOCK  ORANGE (TYPE B), (FACTORY ALARM ARM wire) NOTE #3  @ POWER WINDOW Master Switch,(GRAY, 37-Pin Plug) Pin 28
 POWER UNLOCK  BROWN (TYPE B) and WHITE (TYPE B), (FACTORY ALARM DISARM wire) Requires Double Pulse, NOTE #3 AND #4  @ POWER WINDOW Master Switch,(GRAY, 37-Pin Plug) Pins 29 and 31
 DOOR TRIGGER  BROWN (-)  @ DRIVERS DASH FUSE BOX, (LT.GREEN 16-Pin Plug) Pin 12
 DOMELIGHT SUPERVISION  PINK (-)  Below DRIVERS DASH FUSE BOX, (WHITE, 4-Pin Plu) Pin 2 or WHITE 20-Pin Plug, Pin 12
 TRUNK RELEASE  Use Trnk Release Motor wire  
 SLIDING POWER DOOR  N/A  
 HORN  ORANGE or GREEN/YELLOW (-)  @ HORN SWITCH or DRIVERS DASH FUSE BOX, (LT.GREEN 33-Pin Plug) Pin 23
 TACH  Any wire NOT YELLOW/BLACK (INLINE 4), YELLOW (V6) (AC)  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  LT. GREEN (+)  @ BRAKE SWITCH or DRIVERS DASH FUSE BOX, (LT.GREEN 33-Pin Plug) Pin 2
 FACTORY ALARM DISARM   See POWER UNLOCK  
 ANTI-THEFT  HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. (For Remote Starting/Door Locks) Part # DB-ALL (No Extra Key Required for Operation) 1-KEY Required for Programming. To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: the RIGHT FRONT wire is GRAY (+) @ the PASSENGER KICK FUSE BOX, (LT. GREEN, 16-Pin Plug) Pin 11 NOTE #3: TEST these wires while turning the Key in the Drivers Door. NOTE #4: the BROWN (-) is the DOOR Key Cylinder UNLOCK wire and WHITE(-) is the DOOR UNLOCK Detection wire. Use BOTH wires and Diode Isolate. NOTE #5: on the 2-DOOR, this wire is located in the Drivers Kick Panel. On the 4-DOOR, this wire is located @ DRIVERS DASH FUSE BOX, (GREEN 16-Pin Plug) Pin 9