PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) or PURPLE (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | WHITE (+), See NOTE #5 | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | BROWN (+) | @ HEADLIGHT SWITCH or in DRIVERS KICK PANEL |
POWER LOCK | LIGHT BLUE (TYPE A) | IN EITHER DOOR BOOT |
POWER UNLOCK | WHITE (TYPE A) | IN EITHER DOOR BOOT |
DOOR TRIGGER | PURPLE (-) | @ HEADLIGHT SWITCH |
DOMELIGHT SUPERVISION | WHITE (-) (Requires Part #775 Relay) | @ UNDERDASH LIGHT |
TRUNK RELEASE | BLACK or BLACK/WHITE, See NOTE #2, (Requires Part #775 Relay) | LOW IN DRIVERS KICK PANEL |
SLIDING POWER DOOR | N/A | |
HORN | BLACK (-) | @ STEERING COLUMN HARNESS |
TACH | WHITE (AC) | @ ECM, See NOTE #3 |
WAIT TO START LIGHT | DARK BLUE (-), See NOTE #4 | @ INSTRUMENT CLUSTER |
BRAKE | WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | N/A | |
ANTI-THEFT | YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used) | GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column. |
EXTRA INFORMATION |
NOTE #1: This vehicle uses GM'S PASSLOCK 2 ANTI-THEFT SYSTEM that requires a 791 Bypass Module to Remote Start, to order go to the SECURITY BYPASS MODULES Page on this website. NOTE #2: on vehicles with REAR LIFT WINDOWS it is a (+) Positve system, on vehicles with the CARGO DOORS it is a 5-Wire System See DIAGRAM NOTE #3: the ECM (Electronic Control Module) is located on the DRIVERS SIDE INNER FENDER, the TACH wire is in a BLACK Plug marked WHITE. NOTE #4: when hooking up a remote starter, if you cannot get the (+) or (-) Wait to Start wire on the Remote Starter to work properly, you will then need to disconnect this wire and Program the Remote Starter for the 5, 10, 15 or 20 Second Wait to Start Timmer in the Installation manual. NOTE #5: IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!! |