NOTE #1: THIS VEHICLE REQUIRES A SPECIAL INTERFACE BYPASS MODULE TO REMOTE START
and do KEYLESS ENTRY, PART # DB-ALL or XK09, TO ORDER PLEASE GO TO THE
INTERFACE BYPASS MODULE PAGE ON THIS WEBSITE. IF YOU ARE NOT DOING KEYLESS
ENTRY YOU CAN USE THE 791 BYPASS MODULE.
NOTE #2: The BCM (Body Control Module) is located UNDER the drivers side of dash.
The unit has (6) plugs on it with the PUPRLE Plug on the back of the unit.
NOTE #3: on the BASE model trucks the wires are in the LIGHT BLUE PLUG at the BCM, PINS B4
and B5. On the 4 door trucks the DRIVERS REAR door is a LIGHT BLUE/BLACK (-) PIN
A3 and the PASSENGERS REAR DOOR is a LIGHT GREEN/BLACK (-) PIN A2 these wires
are in the the PURPLE PLUG at the BCM.
NOTE #4: The PCM (Powertrain Control Module) is located in the LEFT FRONT of the engine
compartment to the left of the fan shroud. On DIESELS the TACH wire is at the BLACK
PLUG, PIN 55 and on the hybrid models the tach wire is in a GREEN PLUG PIN 35
NOTE #5: when hooking up a remote starter, if you cannot get the (+) or (-) Wait to Start wire
on the Remote Starter to work properly, you will then need to disconnect this wire
and Program the Remote Starter for the 5, 10, 15 or 20 Second Wait to Start Timmer
in the Installation manual.
NOTE #6: IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for
REMOTE STARTING!!!!!!
|