PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | WHITE (+), See NOTE #4 | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | GRAY/BLACK (-) | @ HEADLIGHT SWITCH |
PARKING LIGHTS ( + ) | BROWN (+) | IN DRIVERS KICK PANEL |
POWER LOCK | See NOTE #1 | |
POWER UNLOCK | See NOTE #1 | |
DOOR TRIGGER | See NOTE #2, (Requires Part #775 Relay) | |
DOMELIGHT SUPERVISION | GRAY/BLACK (-), (Requires Part #775 Relay) | IN DRIVERS DOOR MODULE in DOOR |
TRUNK RELEASE | N/A | |
SLIDING POWER DOOR | N/A | |
HORN | BLACK (-) | @ STEERING COLUMN HARNESS |
TACH | WHITE (AC) | @ PCM, BLUE Plug Pin 49, See NOTE #4 |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN (-) | @ DRIVER DOOR MODULE in DRIVERS DOOR. |
ANTI-THEFT | YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used) | GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column. |
EXTRA INFORMATION |
NOTE #1 This vehicle will Requires a Anti-Theft Bypass Module Part GMDL-BP to connect the Door Locks and Bypass the PASSLOCK 2 System. If not connecting up the Door locks use a 791 or the GMBP Bypass module. NOTE #2: This vehicle has 4 door pin trigger wires, DRIVERS DOOR is a GRAY/BLACK (-) in the DRIVERS DOOR MODULE in the DRIVERS DOOR, the PASSENGER DOOR is a BLACK/WHITE (-) in the PASSENGERS DOOR at the PASSENGER DOOR MODULE, the DRIVERS REAR DOOR is a LIGHT BLUE/BLACK (-) and the PASSENGERS REAR DOOR is a LIGHT GREEN/BLACK (-) the wires are located at the FUSEBOX under the DRIVERS REAR SEAT. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE #3: The PCM (Power Control Module) is located on the DRIVERS SIDE of the ENGINE NOTE #4: IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!! |