Gmc  Acadia 2007-2008
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED/WHITE (+)   @ IGNITION SWITCH HARNESS
 STARTER  See NOTE #1  
 STARTER 2  N/A  
 IGNITION 1  PINK (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BROWN (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  BROWN/WHITE (-)  @ HEADLIGHT SWITCH
 PARKING LIGHTS ( + )  PURPLE (+) AND BROWN/WHITE (+)  IN EACH KICK PANEL
 POWER LOCK  See NOTE #1  
 POWER UNLOCK  See NOTE #1  
 DOOR TRIGGER  SEE NOTE #2  
 DOMELIGHT SUPERVISION  GRAY/BLACK (+)  @ BCM, TO THE LEFT OF STEERING COLUMN
 TRUNK RELEASE  GRAY (-)  @ BCM, TO THE LEFT OF STEERING COLUMN
 SLIDING POWER DOOR  N/A  
 HORN  TAN (-)  @ STEERING COLUMN HARNESS
 TACH  Any wire NOT PINK/BLACK (AC)  @ FUEL INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  LIGHT BLUE (+) ,SEE NOTE #3  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   LIGHT GREEN (-)  @ BCM, TO THE LEFT OF THE STEERING COLUMN
 ANTI-THEFT  REQUIRES INTERFACE BYPASS MODULE, See NOTE #1  
 EXTRA INFORMATION
 NOTE #1: THIS VEHICLE REQUIRES A SPECIAL INTERFACE BYPASS MODULE TO REMOTE START and do KEYLESS ENTRY, PART # DB-ALL or XK09 and will also require part # RFLCHGM TO ORDER PLEASE GO TO THE INTERFACE BYPASS MODULE PAGE ON THIS WEBSITE. NOTE #2: ON VEHICLES WITH EXPRESS DOWN ONLY!! POWER WINDOWS, THE LEFT FRONT DOOR IS GRAY/BLACK (-) AND THE RIGHT FRONT DOOR IS TAN/WHITE (-). THESE WIRES ARE LOCATED AT THE BCM (PINK PLUG) TO THE LEFT OF THE STEERING COLUMN.ON VEHICLES WITH EXPRESS UP AND DOWN POWER WINDOW, THE WIRES ARE THE SAME COLOR THERE JUST IN A DIFFERANT LOCATION. THE LEFT FRONT DOOR TRIGGER WIRE IS LOCATED IN THE DRIVERS DOOR MODULE INSIDE THE DRIVERS DOOR. THE RIGHT DOOR TRIGGER WIRE IS LOCATED IN THE PASSENGER DOOR MODULE INSIDE THE PASSENGER DOOR.THE REAR DOOR TRIGGERS ARE LOCATED AT THE BCM TO THE LEFT OF THE STEERING COLUMN. THE LEFT REAR DOOR TRIGGER LIGHT BLUE/BLACK (-). THE RIGHT REAR DOOR TRIGGER IS LIGHT GREEN/BLACK (-). USE ALL 4 WIRES AND DIODE ISOLATE EACH. NOTE #3: THIS WIRE WILL ONLY TEST WITH THE KEY IN THE ON POSITION.