Ford  Windstar 2001-2004
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+) and LIGHT GREEN/PURPLE (+)   @ IGNITION SWITCH HARNESS
 STARTER  GREEN (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  WHITE/YELLOW (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  YELLOW (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  BLACK/GREEN (+)  @ IGNITION SWITCH HARNESS
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  See NOTE #2  See DIAGRAM
 POWER LOCK  LIGHT BLUE/ORANGE (TYPE B)  @ FEM, 20 Pin PLug, See NOTE #3
 POWER UNLOCK  LIGHT GREEN/YELLOW (TYPE B)  @ FEM, 20 Pin Plug, See NOTE #3
 DOOR TRIGGER  BROWN/PINK (-), See NOTE #4  IN PASSENGERS D PILLAR, See DIAGRAM
 DOMELIGHT SUPERVISION  USE DOOR TRIGGER, (Requires Part #775 Relay)  
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  WHITE/LIGHT GREEN (-) (Left) and GREEN/RED (-) (Right) See NOTE #6  @ OVERHEAD CONSOLE SWITCHES
 HORN  ORANGE/RED (-)  @ FEM, 12 Pin Plug, See NOTE #3
 TACH  See NOTE #5  
 WAIT TO START LIGHT  N/A  
 BRAKE  RED/LIGHT GREEN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   LIGHT BLUE/BLACK (-)  @ FEM, 26 Pin Plug, See NOTE #3
 ANTI-THEFT  FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: This vehicle requires a Special Parking Light Daigram and 2 extra Relays part #775, to connect, See DIAGRAM NOTE #3; The FEM (Front Electronic Module) is located under the Drivers side of the dash on the firewall. NOTE #4: The BROWN/PINK wire must have a 1 AMP DIODE installed to prevent false alarms, when connecting to an ALARM SYSTEM, to connect, See DIAGRAM NOTE #5: The COIL PACK is located on the DRIVERS SIDE of the ENGINE, for TCH use the PINK/WHITE, RED/LIGHT BLUE or BLUE/LIGHT GREEN NOTE #6: the Sliding Doors on this vehicle are a (-)Negative type and there is a wire for each door, to connect will require a Relay part # 775 for each door.