| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | YELLOW (+) and LIGHT GREEN/PURPLE (+) | @ IGNITION SWITCH HARNESS |
| STARTER | RED/LIGHT BLUE (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | RED/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | RED/BLACK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | GRAY/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | BLACK/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BROWN (+) | @ HEADLIGHT SWITCH or at FUSEBOX |
| POWER LOCK | PINK/YELLOW (TYPE B) | IN DRIVERS KICK PANEL |
| POWER UNLOCK | PINK/LIGHT GREEN (TYPE B) | IN DRIVERS KICK PANEL |
| DOOR TRIGGER | BLACK/LIGHT BLUE (+) | @ UNDER DASH LIGHT |
| DOMELIGHT SUPERVISION | USE DOOR TRIGGER | |
| TRUNK RELEASE | PINK/YELLOW (-) or GRAY/RED (+), See NOTE #2 | @ TRUNK RELEASE SWITCH |
| SLIDING POWER DOOR | N/A | |
| HORN | PURPLE/ORANGE (-) | @ 4-Pin PLug to the RIGHT of the STEERING COLUMN |
| TACH | YELLOW/WHITE (AC) | @ IGNITON COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | RED/LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | PINK/WHITE (-) | IN DRIVERS KICK PANEL |
| ANTI-THEFT | FORD'S ANTI-THEFT (Some Vehicles) TRANSPONDER SYSTEM, SEE NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: Some of these vehicles use a Special Anti-theft key to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to operate, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass modlue, this is Part # PKALL or P KFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website NOTE #2: There are (2) wires at this TRUNK RELEASE SWITCH, if the switch has a PINK/YELLOW and a YELLOW/LIGHT GREEN, use the PINK/YELLOW as a (-) Negative Trunk Release. If the switch has a YELLOW/LIGHT GREEN and a PURPLE/YELLOW use the YELLOW/LIGHT GREEN as a (+) Positive Trunk Release. |