Ford  Fusion 2006-
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   BROWN/RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  BLUE/WHITE (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  WHITE/ORANGE (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  PURPLE/GREEN (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  GRAY (-)  @ HEADLIGHT SWITCH or SJB, Connector D, Pin 5, See NOTE #2
 PARKING LIGHTS ( + )  GRAY/YELLOW (+)  IN DRIVERS KICK PANEL or SJB, Connector E, Pin 30, See NOTE #2
 POWER LOCK  GRAY/YELLOW (TYPE B)  IN DRIVER KICK PANEL or SJB, Connector C, Pin 4, See NOTE #2 and NOTE #3
 POWER UNLOCK  PURPLE/GRAY (TYPE B)  IN DRIVERS KICK PANEL or SJB, Connector C, Pin 10, See NOTE #2 and NOTE #3
 DOOR TRIGGER  Use DOME LIGHT SUPERVISION wire  
 DOMELIGHT SUPERVISION  BLUE (+)  IN DRIVERS KICK PANEL or SJB, Connector E, Pin 16, See NOTE #2 and NOTE #4
 TRUNK RELEASE  BROWN (-), (Requires Part #775 Relay)  @ TRUNK RELEASE SWITCH or SJB, Connector D, Pin 27, See NOTE #2
 SLIDING POWER DOOR  N/A  
 HORN  BLUE/WHITE (-)  @ HORN SWITCH or SJB, Connector B, Pin 6, See NOTE #2
 TACH  Any wire NOT GRAY or WHITE/BLUE (AC)  @ Any FUEL-INJECTOR or IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  PURPLE/WHITE (+)  @ SWITCH above BRAKE PEDAL or SJB, Connector A, Pin 19, See NOTE #2
 FACTORY ALARM DISARM   PURPLE/BROWN (-)  IN DRIVERS KICK PANEL or SJB, Connector C, Pin 5, See NOTE #2 and NOTE #5
 ANTI-THEFT  FORD'S TRANSPONDER SYSTEM, SEE NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: the SJB (Smart Junction Box) is part of the FUSE/RELAY BOX under the DRIVERS SIDE of the DASH. NOTE #3: On Vehicles with MEMORY SEATS, the POWER LOCK and UNLOCK wires are in the PASSENGER KICK PANEL or SJB (Smart Junction Box) and you will need to TEST these wires while using the LOCK/UNLOCK Switch on the Passenger Door only. NOTE #4: the DOMELIGHT SUPERVISION wire BLUE (+) can also be located in the PASSENGER side "A" Pillar. NOTE #5: Test this wire will turning the Key in the Drivers Door Key Cylinder.