| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | GRAY/BLACK (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | GREEN/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | ORANGE/YELLOW (+) | @ HEADLIGHT SWITCH |
| POWER LOCK | BLACK/RED (TYPE B) | IN DRIVERS KICK PANEL |
| POWER UNLOCK | BLACK/YELLOW (TYPE B) | IN DRIVERS KICK PANEL |
| DOOR TRIGGER | BLACK/YELLOW (-) and BLACK/BLUE (-) use Both, See NOTE #2 | LOW IN DRIVERS KICK PANEL, See NOTE #2 |
| DOMELIGHT SUPERVISION | USE DOOR TRIGGER, (Requires Part #775 Relay) | |
| TRUNK RELEASE | BLACK/YELLOW (-), (Requires Part #775 Relay) | @ TRUNK RELEASE SWITCH or KEYLESS ENTRY MODULE, See NOTE #4 |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/BLUE (-) | @ STEERING COLUMN HARNESS |
| TACH | BLACK/GREEN (AC) | @ IGNITON COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | LIGHT GREEN/RED (+) | @ SWITCH ABOVE BRAKE PEDAL, See NOTE #3 |
| FACTORY ALARM DISARM | N/A | |
| ANTI-THEFT | FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: This vehicle has (2) door trigger wires, when connecting to an ALARM SYSTEM, use both wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #3: The IGNITION SWITCH MUST be turned on before the Brake wire will test properly. NOTE #4: The FACTORY KEYLESS ENTRY Module (if so equipped) is located behind and to the right of the GLOVE BOX. |