Ford Flex 2009-2012 Printer Friendly Wiring Chart

Ford Flex 2009-2012

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	@ SJB, BLACK 1-PIN PLUG, PIN 1, SEE NOTE #2
STARTER	BLUE/WHITE (+)	@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 7
STARTER 2	N/A
IGNITION 1	WHITE/ORANGE (+)	@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 1
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	VIOLET/GREEN (+)	@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 6
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	VIOLET/WHITE (+)	IN DRIVERS KICK PANEL or SJB, GRAY, 13-PIN PLUG(B), PIN 6, SEE NOTE #2
POWER LOCK	BLUE/GREEN (TYPE B)	IN DRIVERS KICK PANEL or SJB, GRAY, 26-PIN PLUG(C), PIN 17, SEE NOTE #2
POWER UNLOCK	YELLOW/VIOLET (TYPE B)	IN DRIVERS KICK PANEL or SJB, GRAY, 26-PIN PLUG(C), PIN 4, SEE NOTE #2
DOOR TRIGGER	GREEN/VIOLET (-)	IN DRIVERS KICK PANEL or SJB, GRAY, 26-PIN PLUG(C), PIN 14, SEE NOTE #2
DOMELIGHT SUPERVISION	GRAY/VIOLET (+)	IN PASSENGER KICK PANEL or SJB, GRAY, 14-PIN PLUG(A), PIN 9, SEE NOTE #2
TRUNK RELEASE	BROWN (-)	IN DRIVERS KICK PANEL or BCM, GRAY, 26-PIN PLUG(C), PIN 7, SEE NOTE #2
SLIDING POWER DOOR	N/A
HORN	BLUE/WHITE (-)	@ HORN SWITCH or BCM, BLACK 52-PIN PLUG(B), PIN 41, SEE NOTE #2
TACH	Any wire NOT BLUE or BLACK (AC)	@ ANY FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	VIOLET/WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	GREEN/VIOLET (-)	IN DRIVERS KICK PANEL
ANTI-THEFT	FORDS TRANSPONDER ANTI-THEFT, SEE NOTE #1	@ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. If the key has an "SA" stamped into the metal shaft the vehicle will require Part # PKTX interface module. PKALL or PKFM are not required for "SA" key. NOTE #2: The SJB,(Smart Junction Box) is located under the drivers side of the dash.