PART | COLOR | LOCATION |
12 VOLT CONSTANT | YELLOW (+) and LIGHT GREEN/PURPLE (+) | IGNITION SWITCH HARNESS |
STARTER | GREEN (+) | IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | RED/LIGHT GREEN (+) or WHITE/YELLOW (+) | IGNITION SWITCH HARNESS |
IGNITION 2 | RED/BLACK (+) | IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | GRAY/YELLOW (+) | IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | BLACK/LIGHT GREEN (+) | IGNITION SWITCH HARNESS |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | BROWN (+) | @ HEADLIGHT SWITCH |
POWER LOCK | WHITE/RED (TYPE B) | @ VSM, See NOTE #2 |
POWER UNLOCK | BLACK/WHITE (TYPE B) | @ VSM, See NOTE #2 |
DOOR TRIGGER | BLACK/LIGHT BLUE (+) | IN EITHER KICK PANEL |
DOMELIGHT SUPERVISION | USE DOOR TRIGGER | |
TRUNK RELEASE | N/A | |
SLIDING POWER DOOR | N/A | |
HORN | BLUE (-) | @ STEERING COLUMN HARNESS |
TACH | See NOTE #3 | @ IGNITION COIL PACK |
WAIT TO START LIGHT | See NOTE #4 | |
BRAKE | LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | N/A | |
ANTI-THEFT | FORDS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass modlue, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: The VSM (Vehicle Security Module) is located to the RIGHT of the Gas Pedal, just above the transmission hump below the Radio, it is not accessible from the radio opening. NOTE #3; At the COIL PACK use the wire that is NOT RED/LIGHT GREEN. NOTE #4: The DIESEL TACH wire is a GREEN/WHITE wire in a 5-wire harness held up with WHITE tape behind the parking Brake release. DO NOT USE the WAIT TO START WIRE, you will need to program the Remote Starter for the WAIT to START TIMER MODE for the DIESEL Start to work properly. |